Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
- 8. Systems of start, ignition
   - 8.1.1. Introduction
      8.1.2. Technical characteristics
      + 8.1.3. The accumulator
      - 8.1.4. The Generator / system of additional charge of the accumulator
         8.1.4.1. Malfunctions of the generator
      8.1.5. Replacement of the holder of brushes and a regulator of pressure of the generator
      8.1.6. Check of system of start of the engine
      8.1.7. A starter
      8.1.8. An inlet gas pipeline
      8.1.9. A cable of gas/lever throttle заслонки (DB)
      8.1.10. A cable of management of gas (DB)
      8.1.11. A contour of fuel of the diesel engine
      8.1.12. Prestarting heating of diesel fuel
      8.1.13. The fuel thermostat
      8.1.14. The hydrovalve case
      8.1.15. A cable of gas/lever throttle заслонки (ДД)
      8.1.16. A cable of management of gas (ДД)
   + 8.2. Ignition system (petrol engines)
   + 8.3. System of prestarting heating (diesel engines)
   + 8.4. System of release of the fulfilled gases
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

8.1.4. The Generator / system of additional charge of the accumulator
THE GENERAL DATA

If the alarm bulb of system of ignition does not light up at ignition inclusion, check up connecting wires, a bulb and a cartridge.

If the alarm bulb lights up at engine work, muffle the engine and check up a tension drive a belt, connecting wires of the generator and a condition of the generator. Check up a voltage stabilizer. If you could not find out malfunction, address to experts.

Removal
PERFORMANCE ORDER
1. Remove приводной a generator belt.
2. Disconnect wires from the generator.
3. Turn off the bottom fixing bolt and a nut (on engines AAT).
4. Turn off the top fixing bolt of the generator.
5. Remove the generator.

Installation

PERFORMANCE ORDER
Installation is spent upside-down removals. Tighten fixing bolts till the demanded moment of an inhaling.


On the main page