Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
- 8. Systems of start, ignition
   - 8.1.1. Introduction
      8.1.2. Technical characteristics
      + 8.1.3. The accumulator
      + 8.1.4. The Generator / system of additional charge of the accumulator
      8.1.5. Replacement of the holder of brushes and a regulator of pressure of the generator
      8.1.6. Check of system of start of the engine
      8.1.7. A starter
      8.1.8. An inlet gas pipeline
      8.1.9. A cable of gas/lever throttle заслонки (DB)
      8.1.10. A cable of management of gas (DB)
      8.1.11. A contour of fuel of the diesel engine
      8.1.12. Prestarting heating of diesel fuel
      8.1.13. The fuel thermostat
      8.1.14. The hydrovalve case
      8.1.15. A cable of gas/lever throttle заслонки (ДД)
      8.1.16. A cable of management of gas (ДД)
   + 8.2. Ignition system (petrol engines)
   + 8.3. System of prestarting heating (diesel engines)
   + 8.4. System of release of the fulfilled gases
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

8.1.5. Replacement of the holder of brushes and a regulator of pressure of the generator

PERFORMANCE ORDER

1. Remove the generator.

2. Turn off fixing screws (are specified by arrows).

3. Release clips.

4. Uncover.

5. Turn off fixing screws and remove the holder of brushes / a pressure regulator.

6. Measure length of brushes of the generator in points And and V.Zamenite the holder together with brushes if it is necessary.

7. Examine a surface токосъемных rings (are specified by arrows) and replace them if it is necessary.

8. Generator assemblage is spent upside-down.

On the main page