Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation

10.1.7. Plugs of pedals of a brake and coupling

THE GENERAL DATA

Brake pedal / the Hydraulic booster of brakes

1. At плотнительное a ring Establish on an arm of pedals before installation of the hydraulic booster of brakes 2. An arm of pedals Remove at removal of pedals of a brake or coupling 3. A returnable spring of a pedal of coupling Do not grease a spring 4. A clip 5. The main brake cylinder Repair or replace, if it proceeds 6. 20 Н.м. 7. A counternut 8. A pin 9. A plug 10. A clip Always replace 11. 25 Н.м. Always replace 12. Колодка pedals 13. A coupling pedal

14. The stoplight switch Adjustment: press a brake pedal Insert the stoplight switch against the stop Hand pull out a brake pedal back against the stop 15. A clip 16. A pin 17. A brake pedal 18. An accelerator pedal Fastens to an arm by means of a clip 19. A clip 20. A plug 21. A counternut 22. A returnable spring Establish the bent end on a brake pedal 23. 25 Н.м. Always replace 24. 10 Н.м. 25. The hydraulic booster of brakes To replace entirely Before installation, adjust a plug

Adjustment of a plug of a pedal of a brake

PERFORMANCE ORDER

And = 269.0 + 0.5 mm The prevention At carrying out of measurements draught should be at right angle to an amplifier surface.

Plug of a pedal of coupling, adjustment

PERFORMANCE ORDER

And = 116.0 + 0.2 mm The prevention If the coupling pedal does not come back in initial position though the plug is adjusted correctly, it can be caused that in hydraulic systems air or the pedal plug too hard has got.