Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation

10.2. Hydraulic components

THE GENERAL DATA

Support of a forward brake – Girling

1. Dustproof 2. The piston 3. A dustproof ring 4. An arm brake колодок If protective caps have been damaged, establish the repair complete set, a detail 443 698 470 Grease directing pins with applied greasing

5. A piston epiploon 6. A support 7. 35 Н.м. Always replace At untwisting / a twisting keep directing pin a key with накидной a head 8. The screw of an aperture of release of air

At repair use all elements of a repair set.

Support of a forward brake – Teves

1. A directing pin The inhaling moment: 25 Н.м. 2. The screw of an aperture of release of air 3. A support 4. A piston epiploon 5. A dustproof cover

6. The piston 7. An arm brake колодок 8. The rubber plug 9. The plug 10. A dustproof cap 11. A cap

At repair use all elements of a repair set.

---

The prevention

Before installation grease epiploons and pistons of supports with greasing VW of the brake cylinder or similar to it.

---

Support of a back brake – Girling

1. Самоконтрящиеся bolts. The inhaling moment: 35 Н.м. Always replace Keep directing pins at a twisting and untwisting 2. A support Replace a support if it proceeds in an installation site of the lever of a manual brake 3. A piston epiploon 4. The piston 5. A dustproof ring

6. An arm brake колодок If protective caps have been damaged, establish the repair complete set, a detail 443 698 470 Grease directing pins with applied greasing 7. A protective cap 8. A directing pin Grease before installation of a protective cap 9. The screw of an aperture of release of air 10. A dustproof cap

At repair use all elements of a repair set.

New supports of brakes are on sale filled with a brake liquid and pumped over.

Grease pistons and cylinders of supports, and also epiploons with a thin layer of a liquid of the brake cylinder before installation.

Support with two pistons – for all-wheel drive and models with 20 клапанными engines, and also compartment models

1. The screw of an aperture of release of air Grease a screw carving with a thin layer of a liquid of the brake cylinder before installation 2. 35 Н.м. 3. A support 4. A directing pin Grease before cap installation 5. A cap Fastens to an arm колодок and to directing pin 6. An arm brake колодок Grease directing pins with applied greasing

If protective caps have been damaged, establish the repair complete set, a detail 443 698 470 which is on sale as the spare part with preliminary greased directing pins 7. A dustproof ring Put on external edge the piston The internal edge is established in a flute on a support 8. The piston 9. A piston epiploon 10. A dustproof cap

At repair use all elements of a repair set.

---

The prevention

Before installation grease epiploons and pistons of supports with greasing VW of the brake cylinder or similar to it.

---