|
Audi 80/90/CoupeSince 1986-1991 of releaseRepair and car operation |
|
Audi 80/90/Coupe + 1.2. Car identification + 2. Engines, carburettors 3. Greasing system + 4. Cooling system + 5. Fuel system + 6. An exhaust system + 7. Ignition system + 8. Transmission + 9. Suspension brackets, wheels - 10. Brake system 10.1.2. Brake Pads forward brakes 10.1.3. Brake Pads back brakes 10.1.4. The general adjustment of back brakes (Girling) 10.1.5. Replacement brake колодок (all-wheel drive models) 10.1.6. The general adjustment of back brakes (Girling) (all-wheel drive models) 10.1.7. Plugs of pedals of a brake and coupling 10.1.8. Adjustment of a manual brake 10.1.9. Removal of the lever of a manual brake + 10.2. Hydraulic components - 10.3. Antiblocking system of brakes 10.3.2. The hydraulic pump 10.3.3. The electronic block of management + 10.3.4. Elements ABS of a forward wheel + 10.3.5. Elements ABS of back brakes 10.3.6. Broad-brush observations on repair + 11. A steering + 12. A body, salon + 13. A central air + 14. An electric equipment |
10.3. Antiblocking system of brakes10.3.1. Work with system of antiblocking of brakes
The system of antiblocking of brakes (ABS) basically does not demand service. The heat and electric categories can damage system ABS. Disconnect a socket of connection from the management block before electric welding use at car repairs. It is impossible to subject the management block to a heat, above 95оС, such as for example, in the furnace for drying of a body after colouring or a blowtorch even for short time, and also, it is impossible to subject the management block to temperature more low-85oS more, than within 2 hours. Remove the block of management from the car if it is necessary. At check ABS do not maintain the car at the connected instrumentations. Check after repair of brake system After repair or replacement – Brake колодок; After repair of elements ABS, such as – The hydraulic pump; |
On the main page
|