Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation


Audi 80/90/Coupe
+ 1.2. Car identification
- 2. Engines, carburettors
   2.1.2. Removal and engine installation (5-cylinder models)
   2.1.3. Dismantling and assemblage of engines
   2.1.4. A head of the block of cylinders, the mechanism timing
   - 2.2. An engine electric equipment
      2.2.2. A tension клинового a belt
      2.2.3. A klinovoj belt of the generator of an alternating current
      2.2.4. A regulator of pressure of the generator of an alternating current
      2.2.5. The vacuum amplifier
      2.2.6. Vacuum final valves
      2.2.7. The switches established on a steering column
      2.2.8. Check of vacuum system
   + 2.3. Carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment

2.2. An engine electric equipment

2.2.1. The accumulator
THE GENERAL DATA

The accumulator

1. The negative plug
(Smaller diameter)
Clear oxidation traces
Grease кислостойкой with greasing
2. A positive plate
(Dark brown)
3. A divider
(From a dielectric material)
4. A negative plate
(Metal grey colour)
 5. The indicator of level of electrolit
If it is necessary, fill in the distilled water to the indicator
6. The positive plug
(большего diameter)
Clean off oxidation traces
Grease кислостойкой with greasing
7. A cap of a jellied aperture

The accumulator, check / gymnastics

The prevention

Before the beginning of work with electric equipment system, disconnect a wire of the negative plug of the accumulator.

The accumulator, start of the engine from the second accumulator
The prevention

The engine of the car with the charged accumulator should be switched off at connection накидных wires.

PERFORMANCE ORDER
1) connect накидные wires as follows:
1. One end of a positive wire to the positive plug of the charged accumulator
2. The second end of a positive wire to the positive plug of the discharged accumulator
3. One end of a negative wire to the negative plug of the charged accumulator
4. The second end of a negative wire to "weight" of the car with the discharged accumulator
2) the first start the engine of the car with the charged accumulator
3) then the engine of the car with the discharged accumulator
4) disconnect накидные wires upside-down


On the main page