Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation


Audi 80/90/Coupe
+ 1.2. Car identification
- 2. Engines, carburettors
   2.1.2. Removal and engine installation (5-cylinder models)
   2.1.3. Dismantling and assemblage of engines
   2.1.4. A head of the block of cylinders, the mechanism timing
   - 2.2. An engine electric equipment
      2.2.2. A tension клинового a belt
      2.2.3. A klinovoj belt of the generator of an alternating current
      2.2.4. A regulator of pressure of the generator of an alternating current
      2.2.5. The vacuum amplifier
      2.2.6. Vacuum final valves
      2.2.7. The switches established on a steering column
      2.2.8. Check of vacuum system
   + 2.3. Carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment

2.2.3. A klinovoj belt of the generator of an alternating current
THE GENERAL DATA

This subsection describes adjustment operation клинового a generator belt on cars with the 5-cylinder engine and gear рейкой.

Arrangement of elements

PERFORMANCE ORDER
1) ослабьте bolts And and In (gear рейки) on one turn
2) ослабьте шарнирный a support bolt (it is not shown in drawing)
The prevention

Fastening bolts should be weakened enough, that the generator could move freely under the weight.
3) rotation of a tension gear wheel With, achieve a demanded tension клинового a belt (a thumb of a free hand check up a deviation in the middle between two pulleys)
For a new belt the deviation should be about 2 mm
For an old belt the deviation should be about 5 mm
4) keeping a demanded tension, tighten a bolt In to 35 Н.м.
5) tighten a bolt With to 20 Н.м.
6) tighten шарнирный a bolt (it is not shown in drawing) to 35 Н.м.


On the main page