Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
- 8. Transmission
   8.1.2. A plug - the main cylinder of coupling
   8.1.3. Press a coupling disk
   8.1.4. Malfunctions of coupling
   + 8.2. A mechanical transmission 012
   + 8.3. A mechanical transmission 01А
   - 8.4. An automatic transmission 089
      8.4.2. The lever and a rope of the lever of a gear change
      8.4.3. The lock of an automatic gear change
      8.4.4. The mechanism of management throttle заслонкой
      8.4.5. Removal and transmission installation
      8.4.6. Check of the moments of a gear change
      8.4.7. The main transfer
      8.4.8. Differential
   + 8.5. An automatic transmission 087
   8.6. Dismantling and assemblage of automatic transmissions
   8.7. The block of valves
   + 8.8. An automatic transmission 097
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment

8.4.5. Removal and transmission installation

Removal

PERFORMANCE ORDER
1) remove the accumulator
2) remove the top bolts of fastening of the engine and a transmission
3) disconnect a wire of grounding of a transmission
4) disconnect a socket of connection of a speedometer
5) establish a support under the engine
6) lift the car
7) remove bolts from forward fastening of the engine
8) remove a forward exhaust pipe
9) remove a hydrotransformer filter
10) remove bolts of fastening of the hydrotransformer (3 bolts)
11) disconnect hoses of a radiator of a liquid of cooling of an automatic transmission on a back part of the engine, under an accumulator shelf
12) remove a filter on the right party
13) disconnect semiaxes from the main transfer
14) disconnect feeding tube of a liquid of cooling of an automatic transmission
15) remove an arm of a rope of a gear change and disconnect a rope from a transmission
16) remove plastic clips from ropes of seat belts
17) disconnect a rope of an accelerator from the lever of switching of a transmission
18) remove cross-section fastening behind a transmission
19) lift a transmission by means of the lift and remove bolts of fastening of a transmission
20) lower the lift and lift the engine, having lifted an engine support (the transmission thus slightly will bend for simplification of removal)
21) remove remaining bolts of fastening of a transmission and the engine
22) separate the spherical hinge / the case of the bearing of the left wheel and pull out полуось
23) disconnect a transmission from the engine
24) accurately lower the engine, thus support the hydrotransformer that it has not fallen

Installation

Installation is spent upside-down removals, thus pay attention to the following:

Establish and twirl bolts of fastening of a transmission the last.


On the main page