Audi 80/Avant (B4)

Since 1991-1995 of release

Repair and car operation

Check of indicators and signalling devices

Fixing screws (arrows) of a combination of devices become accessible after removal of a covering of a steering column.

The tip (2) can be separated only after it is hooked plastic скоба (3). Another штекерное can be seen fastening on an example of the tip designated in figure (1). Here it is necessary to compress two plastic скобы.

Sit down for a wheel and check up one behind another:

PERFORMANCE ORDER

Whether hours (digital or стрелочные) work?
Include ignition. The indicator of a charge of the storage battery, indicator ABS (for short time), the indicator of a pillow of safety (dies away after approximately 10) and the indicator of a lay brake should flash at the tightened manual brake.
The model which has been not equipped with system of autocheck: in a shone field above between round devices the indicator of temperature of a cooling liquid and the indicator of a signal of braking, the indicator of pressure of oil should blink.
In the car equipped with system of autocheck, in a shone field between round devices at ignition inclusion there is an inscription «Bremslicht» (a brake way). After short pressing a brake pedal there should be a badge «OK» (order).
With small lateness движутся on scales of an arrow of indicators of quantity of gasoline and temperatures of a cooling liquid (only at the heated-up engine).
To include indexes of turns: depending on the chosen direction one of green indicators of indexes of turn should flash rhythmically. To press the switch of the light alarm system: both indicators of indexes of turn and a control lamp of the light alarm system (located in the switch) blink.
To pull the lever of inclusion of a signal of turn to a wheel: the headlight indicator should flash.
To get the engine – whether the manometre works?
During a trial trip to check up indications of a speedometer and the indicator of temperature of a cooling liquid.

Removal of a guard of devices

PERFORMANCE ORDER

To remove a steering wheel (the head the Suspension bracket and a steering)
To remove the top part of a covering of the block with lever switches behind a steering wheel. For this purpose to turn out from below two screws with crosswise шлицем on the right and at the left in the bottom part of a covering and to remove the top part in a direction back.
To weaken two screws with crosswise шлицем in the bottom part of a combination of devices.
Cautiously to extend a guard from the instrument panel.
After fastening removal (to hook upwards plastic скобы or to open fasteners) cautiously to separate the multicontact tip.

On the main page