Audi 80/Avant
+ The description
+ Engines
+ System of release of the fulfilled gases
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and воздухозаборные channels
+ Injection system
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Antiblocking system of brakes
+ Wheels and tyres
+ Kuzovnaja electrosystem
+ Ignition system
+ Illumination
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
- Body elements
Forward bumpers
Forward part of the car
Cowl
Wings
Молдинги
Doors
External rear-view mirrors
The forward and back has flown down
Cover of a luggage carrier at a sedan
Back door of the versatile person
Back bumper
The sdvizhnoj hatch
Procleaning of apertures for a water drain
The control of anticorrosive protection of the bottom of a body
Salon
Seats
+ Search of malfunctions
+ Specifications
|
Salon
Removal of the left shelf
|
|
For shelf removal at the left to weaken bolts with 2 on 5. At installation to insert a shelf ahead in directing (the position 1 shows one of them). |
The left bottom part of a covering of the instrument panel, integrated with a shelf, should be removed almost in all cases when access to an underside of the instrument panel is necessary.
|
|
- Narrow face key to turn out four screws round a shelf.
- A few to cast away a shelf downwards and to extend to itself.
- At installation to insert a covering first line in both cars directing on the bottom and near pedals.
- Not too hardly to tighten screws.
|
|
Removal of a ware box
|
|
The ware box (2 and 3) is attached (1) loops to the instrument panel (arrow). On an illustration the box is shown in the disassembled kind. |
|
|
- To turn out on a bottom edge instrument both panels of the fixing screw of a loop of a ware box.
- Slightly to wring out stoppers of a ware box inside and to cast away a ware box downwards.
|
|
Removal of the bottom part of the central console
|
|
Removal of a back part of the central console: to remove a lath (1), to disconnect a covering of the lever of a lay brake (3), to disconnect an earring (arrows) on the handle (2) from a clamp. |
|
|
- To tighten a lay brake.
- To wring out a screw-driver fixing linings of a cover of the lever of a lay brake and to separate from a floor.
- In front slightly to raise a covering, to wring out a lever earring upwards and to extend the lever forward.
- To raise the decorative panel in front of the lever of a lay brake. Thus to hook an upper edge a small screw-driver.
- To turn out six fixing bolts, being under the panel.
- To remove a back ashtray.
- To turn out under an ashtray two шестигранных a bolt.
- To pull a console part for a first line upwards and to remove it in a direction forward over the lever of a lay brake.
|
|
Removal of a forward part of the central console
|
|
Removal of a forward part of the central console: to turn off a head of the lever of a gear change (2), to weaken a bolt on a casing of the lever (1). (3) – lobbies directing. |
|
|
Arrows show on two bolts located in cut of the panel of heating which are necessary for weakening for removal of the central console. |
|
|
- To disconnect a wire on "weight" of the accumulator.
- Completely to remove a back part of the central console.
- To remove the lever of a gear change or the selector lever.
- To turn away a bolt with crosswise шлицем on back to edge of the console and to remove a cover of the handle of a gear change or a covering.
- To disconnect all three regulators of heating/ventilation.
- To turn away two screws of the panel of heating and to remove it.
- At the cars equipped with the automatic conditioner, completely to remove a control panel.
- Below on the right and at the left in cut of the panel of heating to turn out on one screw.
- To wring out the console with an ashtray downwards, at a variant of a body with additional devices to remove in a direction downwards a narrow decorative plate.
- In a direction to disconnect the console from a control panel back.
- If necessary to disconnect wires.
- At installation directing on the instrument panel and the central console should enter one into another.
|
|
|
On the main page
|