Audi 80/Avant (B4)

Since 1991-1995 of release

Cover of a luggage carrier at a sedan

The lock and замковый a drive in a cover of a luggage compartment of sedan Audi 80


1 – the lock; 2 – сдвижная the button of connecting draught between the lock and the press button;	3 – the press button; 4 – connecting bent for to system of locks with the central management.

Removal

PERFORMANCE ORDER

To open a cover.
A few to cast away a covering of a luggage compartment above the left back dimension.
To separate штекерное connection of wires to a cover of a luggage compartment and to pass tips through the sealing plug in metal.
If the car is equipped by system of locks with the central management, it is necessary to disconnect a hose to a drive of the lock at cover loops.
On the right and at the left to cast away and remove lock скобы on pneumatic springs. After that it is possible to wring out pneumatic springs from spherical heads.
Supporting a cover together, to turn out on the right and at the left two bolts in loops.
To uncover loops.
It is in addition possible to disconnect loops from a body.

Adjustment of a cover of a luggage compartment

Sedan

PERFORMANCE ORDER

It is necessary to achieve an identical backlash between the right both left details of a body and a luggage carrier cover (nearby 4 – 5 mm). Also near back glass the distance to a cover should be identical on the right and at the left.
It is necessary to regulate after easing of fixing bolts of loops on a cover of a luggage compartment.
Besides, the cover should coincide on height with wings. It can achieve after easing of fixing bolts of loops on a lateral wall.
If the luggage carrier cover knocks or is badly closed, it is possible to adjust the lock buffer on the right and at the left above on a lateral part.
To weaken and shift upwards or downwards a fixing bolt, then to tighten again. The lock buffer is established correctly if it without pressure adjoins to the closed cover.
To check up landing and closing of a cover of a luggage compartment, if necessary отюстировать запорную a plate of the lock of a luggage carrier.
The block of headlights in a cover should defend from headlights in a lateral part approximately on 8 mm. It it is possible to reach by moving of the block of headlights in their longitudinal apertures.

Removal of the lock of a luggage carrier

Sedan

PERFORMANCE ORDER

To open a cover of a luggage compartment.
To remove an internal covering under the press button of the lock of a luggage carrier.
Button removal: to take aside lock скобу on приводной to draught and to remove draught.
To disconnect штекерные connections for the microswitch of system of locks with the central management.
To turn out two nuts, to remove in a direction inside the press button with lock cylinders.
Removal замковой parts: to disconnect приводные draughts from the press button (to take aside lock скобу), to separate штекерное connection.
To turn out two шестигранные nuts from below on the lock. To take out the lock in a direction downwards.
At installation замкового an element to adjust length drivers bent for to the press button.
The sdvizhnuju button in the middle of connecting draught to shift back so that draught halves have appeared freely inserted each other.
At an open cover of a luggage carrier to put a latch of the lock to position "is closed".
To insert a six-millimetric drill into an aperture замкового an element, to fix a latch.
In this position to fix one in other carving sites of halves of draught and to stop сдвижной the button.
To remove a drill.

On the main page