|
1. Check up a backlash between electrodes of a candle by means of round probeа. Щуп should move between electrodes under small effort. |
|
2. If necessary turn in a lateral electrode. To turn in an electrode follows near to a bend. Candles turn out on one. |
|
3. Disconnect from a candle a wire, keeping for a tip and slightly them turning. |
|
4. Clear and blow compressed air of a platform near to candles and turn out candles. |
| 5. Check up the turned out candle and estimate an engine condition. |
| 6. Grease a carving of a new candle with structure from прихвата on a copper basis, insert and turn by hand, then tighten with the set moment. |
| 7. Check up a condition of wires (subsection 2.17 see), dress a wire on a candle, slightly rotating tips and pressing on them. Repeat procedure for other candles. |