Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   + 6.1. Models with the carburettor
   + 6.2. Models with system of injection of fuel
   - 6.3. Models with engines 16D and 16DA
      6.3.1. A technical characteristics
      6.3.2. Power supply system clearing
      6.3.3. Replacement of the air filter
      6.3.4. Replacement of the fuel filter
      6.3.5. Plums of fuel from the fuel filter
      6.3.6. A heating element of the fuel filter
      6.3.7. Check and adjustment of turns of idling
      6.3.8. Check and adjustment of the maximum turns
      - 6.3.9. The fuel pump
         6.3.9.1. Check and adjustment
         6.3.9.2. Removal, repair and installation of the fuel pump
      6.3.10. Removal and valve installation отсечки fuel of system of idling
      6.3.11. Removal, repair and installation of atomizers
      6.3.12. Removal and installation of a cable of an accelerator
      6.3.13. Removal and installation of a cable of system of cold start of the engine
      + 6.3.14. Collectors
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





6.3.9. The fuel pump

6.3.9.1. Check and adjustment

Check

PERFORMANCE ORDER
1. Check up adjustment клапанного the mechanism.
2. Establish the piston of cylinder N 1 in position ВМТ at the moment of a compression step. The mark in a pump pulley should be combined with a mark in a pump arm (marks are specified by arrows).
3. Turn a cranked shaft of the engine against a normal direction of rotation so that the mark in a pulley was approximately on 5,0 sm more to the left of mark ВМТ.
4. Remove заглушку from a pump underside.
5. Establish the indicator of hour type (it is specified by an arrow).
6. Again establish the piston of cylinder N 1 in position ВМТ at the moment of a step of compression and compare indications of the gauge to values in subsection 6.3.1.

Adjustment

PERFORMANCE ORDER
1. Loosen the bolts of fastening of halves of a pulley of the fuel pump.
2. Turn an internal part of a pulley against the stop counter-clockwise.
3. Null indications of the indicator and turn an internal part of a pulley clockwise so that the indicator of hour type showed demanded value.

On the main page