Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   + 6.1. Models with the carburettor
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   - 6.4. Models with engines 17D and 17DR
      6.4.1. A technical characteristics
      6.4.2. Power supply system clearing
      6.4.3. Replacement of the air filter
      6.4.4. Replacement of a casing of the air filter
      6.4.5. Replacement of the fuel filter
      6.4.6. Plums of fuel from the fuel filter
      6.4.7. A heating element of the fuel filter
      6.4.8. Check and adjustment of turns of idling
      6.4.9. Check and adjustment of the maximum turns
      6.4.10. Adjustment of the fuel pump
      6.4.11. Check, removal, repair and installation of the fuel pump
      6.4.12. Removal and valve installation отсечки fuel of system of idling
      6.4.13. Removal, repair and installation of atomizers
      6.4.14. Removal and installation of a cable of an accelerator
      6.4.15. Removal and installation of a cable of system of cold start of the engine
      6.4.16. Replacement of a vacuum diaphragm of system of cold start of the engine 17DR
      6.4.17. Collectors
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





6.4.10. Adjustment of the fuel pump
PERFORMANCE ORDER
Pumps Bosch and Lucas/CAV
1. Adjustment operation is similar described in subsection 6.3.9.1 behind that exception that adjusting marks are located a pulley of the fuel pump and an internal casing of a gear belt, and also on a flywheel (in drawing – adjusting marks in a flywheel (the engine 17D).
2. Be convinced that the mark in a pulley is combined with a mark in an internal casing (marks are specified by arrows).
Pump Lucas/CAV
3. Adjustment operation also is similar described in subsection 6.3.9.1 with that difference that the adjusting aperture is located on the top party of the pump. Therefore for carrying out of measurements it is necessary to use a pin in diameter of 7,0 mm.
4. Adjustment of the fuel pump spend with use of a pin and the indicator of hour type (and – an adjusting ledge, х – adjusting distance (it is specified on the pump tablet), y – 95,50,01 mm, z – diameter of 7,0 mm).
5. The adjusting data is resulted in the tablet (it is specified by an arrow).

On the main page