Opel Kadett E

1984-1991 of release

Repair and car operation

Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
- 8. Ignition system
   + 8.1. System of ignition with the breaker
   - 8.2. Electronic contactless system of ignition
      8.2.1. A technical characteristics
      8.2.2. Check of system of ignition
      + 8.2.3. The ignition distributor
      8.2.4. Adjustment of a corner of an advancing of ignition
      8.2.5. Removal, check and installation of the coil of ignition
      8.2.6. Removal and installation of the block of ignition (switchboard)
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

8.2.6. Removal and installation of the block of ignition (switchboard)

THE GENERAL DATA

MODELS 1,3 AND 1,4 L WITH THE CARBURETTOR

The block of management is located by ignition in the ignition distributor.

L MODELS 1,6 (16 SH) WITH THE CARBURETTOR AND MODELS 1,8 OF L (18) WITH SYSTEM OF INJECTION OF FUEL

The block of management is located by ignition on an arm of fastening of the coil of ignition.

PERFORMANCE ORDER

1. For access to the management block remove the ignition coil.

2. Unscrew screws and remove the block of management from an arm of the coil of ignition.

3. At installation of the new block of management by ignition put on an interfaced surface of the block теплопроводную paste.

4. Installation of the block of ignition is made in sequence, return to removal.

5. Thus check up that adjusting pins of the block were accurately established in apertures of an arm of the coil of ignition.

L MODELS 1,6 (16 SV) WITH THE CARBURETTOR AND L MODELS 1,8 (18 SE) WITH SYSTEM OF INJECTION OF FUEL

The block of management is located by ignition in a motor compartment about the top fastening of a rack of a forward suspension bracket.

PERFORMANCE ORDER

1. Remove a wire of weight from the accumulator.

2. Release clamps and disconnect an electric socket from the block of management of ignition.

3. Unscrew screws and remove the block of management of ignition from an arm.

4. Installation is made in sequence, return to removal.

MODELS 1,4 AND 1,6 L WITH SYSTEM OF INJECTION OF FUEL AND ALL MODELS 2,0 OF L

Subsection 6.2.11 and subsection 6.2.12.2 see .

On the main page