Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   + 3.1. 4-cylinder engines
   + 3.2. Engines V6 of 3,0 l (1993-1994) and 3,4 l (since 1995)
   - 3.3. Dismantle and engine major repairs
      3.3.1. Specifications
      + 3.3.2. Major repairs
      3.3.3. Diagnostics of the engine by means of the vacuum gauge
      3.3.4. Compression check in engine cylinders
      + 3.3.5. Dismantle of the power unit
      + 3.3.6. A head of cylinders
      3.3.7. Valves
      3.3.8. Shatunno-piston group
      + 3.3.9. Коленвал
      3.3.10. The block of cylinders
      3.3.11. Хоннингование cylinders
      + 3.3.12. Rods and pistons
      3.3.13. Radical and шатунные bearings
      3.3.14. Balansirnye shaft
      3.3.15. An assembly order
      3.3.16. Piston rings
      3.3.17. Start-up of the engine after repair and обкатка
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

3.3.16. Piston rings

THE GENERAL DATA

Installation компрессионных rings

On rings there are labels (1 (2) Т or 1 (2) N for 4-cylinder engines и1 (2) R or Т1 (т2) for V6).

Installation

PERFORMANCE ORDER

1. Before installation of new piston rings sort rings and check up a backlash in joints. For this purpose push a ring the piston bottom. The ring should be in the bottom part of the cylinder, in the position corresponding to the bottom dead point.

2. Measure a backlash in joints. If the backlash is too small, a ring replace, to file end faces it is forbidden.

3. Establish rings on the piston, having begun with маслосъемного. Establish in a flute a divider / a dilator.

4. Be convinced available a pin (if it is provided) and establish the bottom and top disks. At installation маслосъемных disks to use the adaptation for clothing of rings it is impossible, as their breakage is possible.

5. Be convinced that the top and bottom disks are freely turned in a flute. Establish average and top rings (fig. Installation компрессионных rings see). Labels on rings should be turned to the piston bottom. Establish rings on other pistons.

On the main page