Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
- 7. Transmission elements
   7.1. Specifications
   + 7.2. Coupling
   + 7.3. Карданный () a shaft () and карданные hinges
   7.4. Back and forward axes
   7.5. The bearing, an epiploon and полуось the back bridge
   7.6. An epiploon of a reducer of the back bridge and a forward axis
   7.7. The back bridge
   7.8. Forward semiaxes
   7.9. Replacement of covers and SHRUS dismantling
   + 7.10. An electromagnetic drive of a forward leading axis (ADD-system)
   7.11. A forward reducer
+ 8. Brake system
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

7.9. Replacement of covers and SHRUS dismantling
PERFORMANCE ORDER
The prevention

External SHRUS not folding. More expedient from the point of view of expenses is semiaxis replacement in gathering.
1. Remove полуось.
2. Clamp полуось in a vice through a soft lining. Check up radial люфт the SHRUS and a cover condition. At detection of damages of a cover disassemble the hinge, clear details and examine.
3. Remove collars of covers, having unbent a latch screw-driver.
4. Cautiously remove an external cover (or cut if the cover is strongly damaged).
5. Remove an internal cover from the case of the SHRUS and remove the case.
6. Designate mutual position крестовины and cases.
7. Remove a lock ring.
8. Bring down крестовину from a semiaxis through brass оправку.
9. Cautiously remove covers (if their condition satisfactory). At cover removal wrap up шлицы a tape.
10. Wash out and examine all details. Check up a condition of balls of an external SHRUS. At detection of deterioration of balls replace the hinge (is on sale in gathering with a semiaxis). Examine details of an internal SHRUS, presence of scratches, poles and задиров is not supposed. If necessary replace крестовину.
11. At assemblage dress covers, collars and establish on полуось крестовину (a photo at the left). Grease крестовину and put greasing in the SHRUS case (a photo on the right).
12. After case installation fill cavities with greasing.
13. Dress a cover so that edges have come into flutes. At assemblage sustain the assembly size of a semiaxis.
14. Straighten a cover edge.
15. For collar fastening wring out uvulas (a photo at the left) and bend (a photo on the right).
16. Establish полуось.


On the main page