Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

7.3. Карданный () a shaft () and карданные hinges

THE GENERAL DATA

One-section карданный a shaft of rear-wheel cars "Toyota 4 Runner/Hilux/Surf"

1. A plug with a flange 2. Крестовина 3. A plug of sliding connection 4. Грязеотражатель

5. The bearing 6. A lock ring 7. A kardannyj shaft

Forward and back карданные shaft of all-wheel drive cars "Toyota 4 Runner/Hilux/Surf"

AND: 1, 7. A plug with a flange 2, 3, 6. A butterdish 4. A casing 5. Forward карданный a shaft 8, 12. The bearing 9, 13. A lock ring 10, 14 Krestovina 11. A plug of sliding connection

IN: 1. The bearing 2. A lock ring 3. A plug of sliding connection 4. A plug with a flange 5, 6. A butterdish 7. A casing 8. Back карданный a shaft 9. A plug with a flange

On cars "Toyota 4 Runner/Hilux/Surf" it is established one-section back карданный a shaft with 2 карданными hinges. A forward shaft (on all-wheel drive cars) and a back shaft are equipped sliding шлицевым by connection. This connection is executed at the same time with a plug of the hinge and is a part карданного a shaft.

From outside a distributing box (on all-wheel drive cars) shaft fasten through a flange condensed with 2 epiploons (subsection 6.3.2 see).

At operation care карданными is reduced by shaft to condition check, stock-taking of balancing counterbalances and their fixing, and also to clearing.

Greasings of hinges as a rule it is not required.