Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
- 10. Brake system
   + 10.1.2. Shock-absorbers
   + 10.2. Technical characteristics
   10.3. Prorolling of hydraulic system
   10.4. Hydraulic tubes and hoses
   10.5. Brake overlays of forward brakes
   10.6. Brake overlays of back wheels
   10.7. Brake Pads back brakes
   10.8. A brake disk of a forward wheel
   10.9. A brake disk of a back wheel
   10.10. A brake drum of a back brake
   10.11. A support of a forward brake
   10.12. A support of a back brake
   10.13. The wheel cylinder of a back brake
   10.14. The main brake cylinder
   10.15. A brake pedal
   10.16. The vaakuumnyj amplifier
   10.17. The vacuum valve of a servoamplifier
   10.18. A rope of a manual brake
   10.19. The lever of a manual brake
   10.20. The valve of adjustment of pressure in a contour of back brakes (till 96 of century)
   10.21. The switch of fires of a stoplight
   10.22. The general description of system of antiblocking of brakes (ABS)
   10.23. System ABS elements
   10.24. The vacuum pump (diesel and petrol engines in volume 2,3)
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

10.7. Brake Pads back brakes
THE GENERAL DATA

Elements of a back drum-type brake

1. Клинышек
2. A pusher
3. A lobby brake колодка
4. A spring
5. The top returnable spring
6. A cap
7. The lever manual томоза
8. The bottom returnable spring
9. The wheel cylinder
10. A guard
11. Заглушка
12. Back brake колодка
13. A spring

Replacement

PERFORMANCE ORDER
1. Remove a brake drum.
2. Clear the mechanism of a brake of an asbestine dust (fig. Elements of a back drum-type brake see).
3. Examine brake Pads and measure a thickness of a frictional material. For replacement brake колодок mark installation position колодок and springs.
4. Remove caps and clamping springs.
5. Remove pins of clamping springs колодок.
6. Remove the bottom returnable spring.
7. Remove brake Pads. Put on an elastic band (marksman) the wheel cylinder for fixing of pistons.
8. Mark position of installation of all springs (arrow) and remove them.
9. Installation brake колодок is spent upside-down removals.


On the main page