Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
+ 8. Systems of start, ignition
- 9. Transmission
   - 9.1.2. Technical characteristics
      9.1.3. Prorolling of hydraulic system of a drive of deenergizing of coupling
      9.1.4. Coupling adjustment
      9.1.5. A coupling pedal
      9.1.6. The main cylinder of a drive of deenergizing of coupling
      9.1.7. The working cylinder of a drive of deenergizing of coupling
      9.1.8. A disk of coupling and a casing
      9.1.9. The vyzhimnoj bearing and the lever
      9.1.10. Malfunctions of coupling
   + 9.2. A Mehnichesky transmission
   + 9.3. An automatic transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

9.1.5. A coupling pedal
THE GENERAL DATA

Elements of fastening of a pedal of coupling

1. An arm
2. A nut
3. A washer
4. A brake pedal
5. A spring
6. A washer
7. A tube
8. A coupling pedal
9. The plug
10. A ring
11. The lever
12. The main cylinder of a drive of deenergizing of coupling

13. A bolt
14. A plug
15. A pin
16. A lock ring
17. A bolt
18. An arm
19. A washer
20. A nut
21. A hose
22. A spring
23. A clip
24. The switch of fires of an emergency brake
25. The valve of system of the cruise-control

MODELS WITH RIGHT-HAND MANAGEMENT

Removal

The coupling pedal acts in film together with a fixing arm.

PERFORMANCE ORDER
1. Remove the furnish panel.
2. Disconnect a plug of a pusher of the main cylinder from a pedal of coupling and remove the cylinder from an arm.
3. Disconnect wires from switches on an arm.
4. Turn off fixing nuts and remove an arm together with pedals.

Installation

Installation is spent upside-down removals.

MODELS WITH LINK SIDED MANAGEMENT

Removal
PERFORMANCE ORDER
1. Remove the furnish panel.
2. Disconnect a pusher of the main cylinder from a coupling pedal.
3. Establish a fixing clip on a spring and remove it.
4. Remove a coupling pedal.

Installation

Installation is spent upside-down removals.


On the main page