Audi 100

1982-1990 of release

Repair and car operation



Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
- 12. An electric equipment
   + 12.1. Electric equipment system
   - 12.2. Ignition system
      + 12.2.1. Transistor system of ignition
      - 12.2.2. Electronic system of ignition
         12.2.2.1. Check of the coil of ignition
         12.2.2.2. Check of the gauge of a corner of an advancing of ignition
         12.2.2.3. Check of the gauge of frequency of rotation of a cranked shaft
         12.2.2.4. The gauge of a corner of an advancing of ignition, frequency of rotation of a cranked shaft
         12.2.2.5. Check and replacement of the gauge of temperature of air
         12.2.2.6. Check of the gauge of temperature of a cooling liquid
         12.2.2.7. Switches of a mode of idling and opening throttle заслонки
         12.2.2.8. Check of the gauge of the Hall
         12.2.2.9. Check of the block of management
      12.2.3. Contactless system of ignition FEI
   + 12.3. Electric schemes

12.2.2.4. The gauge of a corner of an advancing of ignition, frequency of rotation of a cranked shaft
THE GENERAL DATA

Suspension bracket connecting колодок on an arm

 1 – колодка the gauge of a corner of an advancing of ignition; black colour;

2 – колодка the gauge of frequency of rotation of a cranked shaft; grey colour;

3 – колодка the detonation gauge; red colour

Backlash check between the gauge of a corner of an advancing of ignition and a flywheel

 1 – a bolt of fastening of an arm;
2 – probe;
3 – the gauge of a corner of an advancing of ignition;
4 – the gauge of frequency of rotation of a cranked shaft;
5 – an arm of fastening of gauges;
6 – a flywheel

Backlash check between the gauge of frequency of rotation of a cranked shaft and a flywheel

1 – probe;

2 – the gauge of frequency of rotation of a cranked shaft;

3 – a flywheel;

4 – a protective cap

Removal and installation

PERFORMANCE ORDER
1. To disconnect Pads.
2. To turn away a bolt and to remove an arm with gauges.
3. To remove transmission, to get access to an engine flywheel.
4. To turn a cranked shaft so that a pin on a flywheel has appeared in cut under the gauge.
5. To establish an arm with the gauge into place and probeом to measure a backlash between a pin of a flywheel and the gauge of a corner of an advancing of ignition and a backlash between the gauge of frequency of rotation of a cranked shaft and a flywheel.
6. The backlash between a pin and the gauge of a corner of an advancing of ignition should be 0,45–1,25 mm, and between a flywheel and the gauge of frequency of rotation – 0,51–1,24 mm.
7. If the measured backlashes differ from specified, to replace an arm of gauges. It is possible to enclose also linings for increase in backlashes or прошлифовать an arm for their reduction.


On the main page