Audi 100

1982-1990 of release

Repair and car operation



Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
- 12. An electric equipment
   + 12.1. Electric equipment system
   - 12.2. Ignition system
      + 12.2.1. Transistor system of ignition
      - 12.2.2. Electronic system of ignition
         12.2.2.1. Check of the coil of ignition
         12.2.2.2. Check of the gauge of a corner of an advancing of ignition
         12.2.2.3. Check of the gauge of frequency of rotation of a cranked shaft
         12.2.2.4. The gauge of a corner of an advancing of ignition, frequency of rotation of a cranked shaft
         12.2.2.5. Check and replacement of the gauge of temperature of air
         12.2.2.6. Check of the gauge of temperature of a cooling liquid
         12.2.2.7. Switches of a mode of idling and opening throttle заслонки
         12.2.2.8. Check of the gauge of the Hall
         12.2.2.9. Check of the block of management
      12.2.3. Contactless system of ignition FEI
   + 12.3. Electric schemes

12.2.2.8. Check of the gauge of the Hall
THE GENERAL DATA

Numbers of contacts connecting Pads the management block

PERFORMANCE ORDER
1. To disconnect the central wire of a high voltage from the distributor of ignition and to connect it to "weight".
2. To disconnect connecting колодку.
3. To connect the voltmeter to extreme contacts «1» and «3», to include ignition. The voltmeter should show pressure about 9 Century Otherwise to check up conducting.
4. To shift back a protective cover with Pads, to connect the voltmeter to contacts «1» and «2» and to establish колодку in a nest on the ignition distributor.
5. To uncover the distributor, бегунок and the antidust screen.
6. To turn a cranked shaft of the engine so that a teeth of an anchor (1) distributors did not block the gauge of the Hall (2). To include ignition. Pressure should be 4 Century
7. To turn a cranked shaft so that one of an anchor teeth it was combined with the Hall gauge. Pressure should decrease to 0–0,5 V.Vykljuchit ignition. If pressure differs from set, to replace the Hall gauge.
8. To connect an ohmmeter to contacts «1» and «4», then with contacts «2» and «27» and, at last, with «3» and «25». Resistance should be equal In all cases to zero. If resistance differs from zero, means in conducting there is a breakage.


On the main page