Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
- 3. Engines
   + 3.1. Four-cylinder engines
   - 3.2. Five-cylinder engines
      3.2.1. Removal and engine installation
      - 3.2.2. Dismantling and engine assemblage
         3.2.2.1. Removal and installation of a head of the block of cylinders
         3.2.2.2. Adjustment and a tension of a belt of a drive of a camshaft
         3.2.2.3. Survey, дефектовка and repair of details of a head of the block
         3.2.2.4. Removal of a camshaft and pushers of valves
         3.2.2.5. Installation of a camshaft and pushers of valves
         3.2.2.6. Removal and installation of valves
         3.2.2.7. Dismantling and assemblage of a drive of a camshaft
         3.2.2.8. Removal and flywheel installation
         3.2.2.9. Removal and installation oil картера
         3.2.2.10. Removal, check and installation of the oil pump
         3.2.2.11. Replacement of epiploons of a cranked shaft
         3.2.2.12. A cranked shaft and shatunno-piston group
   + 3.3. The diesel engine
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

3.2.2.5. Installation of a camshaft and pushers of valves
PERFORMANCE ORDER
1. To grease pushers 19 (fig. the Head of the block of cylinders, a camshaft and valves see), cams and necks of a camshaft with 18 engine oil.
2. To establish in pushers adjusting washers if they are, an inscription downwards.
3. To establish pushers 19 on the places according to earlier made marks.
4. To establish a camshaft 18 on bearings so that cams of 1st cylinder have been directed to pushers.
5. To establish covers of 15 bearings on the places. To wrap nuts of 17 fastenings of covers of bearings №2 and 4 and to tighten them on a diagonal before camshaft fixing in bearings.
6. To wrap nuts of bearings №1 and 3.
7. To tighten all nuts on a diagonal the moment 20 Н·м (2,0 кгс·м)
8. To grease an epiploon with engine oil and with the help оправки запрессовать заподлицо with a surface of a head of a bolt.
9. To establish шпонку 14, to put on a camshaft a cogwheel 11.
10. To twirl a bolt 12 with a washer and to tighten the moment 80 Н·м (8,0 кгс·м).


On the main page