Audi 100

1982-1990 of release

Repair and car operation

3.2.2.8. Removal and flywheel installation

THE GENERAL DATA

Flywheel, cranked shaft, the oil pump

1 – the oil pump; 2 – a lining of the oil pump; 3 – the block of cylinders; 4 – a lining of the holder of an epiploon; 5 – the holder of an epiploon; 6 – an epiploon back a cranked shaft; 7 – a flywheel; 8 – the bearing of a primary shaft of a transmission; 9 – the bottom loose leaf of the radical bearing; 10 – a cover of the radical bearing;

11 – a bolt of fastening of a cover of the radical bearing; 12 – the receiver of the oil pump; 13 – a receiver lining; 14 – a cranked shaft; 15 – the top loose leaf of the radical bearing; 16 – a forward epiploon of a cranked shaft; 17 – a rack of fastening of the top cover of a drive of a camshaft

On cars with automatic transmission instead of a flywheel it is established приводной a disk. A removal and installation order drive a disk same, as for a flywheel.

PERFORMANCE ORDER

1. To mark mutual position of a flywheel and a cranked shaft. 2. In regular intervals to turn away bolts of fastening of a flywheel on 1–2 turns. 3. Gradually in regular intervals to turn out bolts of fastening of a flywheel and to remove a flywheel 7. 4. To establish a flywheel (приводной a disk) upside-down. Before installation to put on a carving of bolts of fastening of a flywheel hermetic. Bolts to tighten the moment 100 Н·м (10 кгс·м). If приводной a disk replaced new, to check up and if it is necessary to adjust its position. The distance from a back wall of the block of cylinders to an adjusting surface of the transformer on приводном a disk should be 17,2–18,8 mm. To adjust position drive a disk it is possible, having established between it and cranked shaft a lining.