Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
- 3. Engines
   + 3.1. Four-cylinder engines
   - 3.2. Five-cylinder engines
      3.2.1. Removal and engine installation
      - 3.2.2. Dismantling and engine assemblage
         3.2.2.1. Removal and installation of a head of the block of cylinders
         3.2.2.2. Adjustment and a tension of a belt of a drive of a camshaft
         3.2.2.3. Survey, дефектовка and repair of details of a head of the block
         3.2.2.4. Removal of a camshaft and pushers of valves
         3.2.2.5. Installation of a camshaft and pushers of valves
         3.2.2.6. Removal and installation of valves
         3.2.2.7. Dismantling and assemblage of a drive of a camshaft
         3.2.2.8. Removal and flywheel installation
         3.2.2.9. Removal and installation oil картера
         3.2.2.10. Removal, check and installation of the oil pump
         3.2.2.11. Replacement of epiploons of a cranked shaft
         3.2.2.12. A cranked shaft and shatunno-piston group
   + 3.3. The diesel engine
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment



3.2.2.4. Removal of a camshaft and pushers of valves
PERFORMANCE ORDER
1. To remove a head of the block of cylinders (subsection 3.2.2 subitem 1-12 see).
2. To turn away a bolt 12 (fig. the Head of the block of cylinders, a camshaft and valves see) and to remove a cogwheel 11 from a camshaft 18. To take out шпонку 14.
3. To turn on on two turns one of nuts of a cover of the bearing №2, considering from a camshaft drive, then to turn on on two turns a nut of the bearing opposite on a diagonal №4. To turn on on two turns other nut of the bearing №2 and the bearing №4. To turn on nuts in that order while they will not turn away completely.
4. Similarly to turn away a nut of bearings №1 and 3.
5. To remove covers of 15 bearings.
6. To take out a camshaft 18
7. To remove an epiploon 13.
8. To remove pushers of 19 valves, preliminary having marked their number of the valve. If a drive of valves with adjusting washers each washer should be stored with the pusher. Hydraulic pushers store turned top downwards.
9. Survey and дефектовку a camshaft and hydropushers spend the same as on the four-cylinder engine (subsection 3.1.2.3, subsection 3.1.2.4 see).

On the main page