Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation

9.1.7. SHRUS (all-wheel drive models)

THE GENERAL DATA

---

The prevention

Semiaxis greasing on cars with a full drive (Quattro): grease an internal and external SHRUS in 90 grammes of greasing G6 everyone.

---

Полуось – for all-wheel drive models

1. A convex washer – 2 types: 1. With internal шлицами 2. With external шлицами At replacement establish a washer of the same type 2. A lock ring Establish in a ring flute on a semiaxis (it is not visible at the established hinge) 3. An external SHRUS Remove only entirely Installation: establish the hinge on полуось with the help киянки so that it was possible to establish a lock ring 4. A persistent washer 5. A convex washer 6. A shlangovyj clip 7. A cover Check up on presence of cracks and wear tracks 8. A clip 9. Полуось Various length on the left and right party 10. A cover with a cover 11. An internal SHRUS External diameter for model Quattro: 100 mm 12. An epiploon Replacement: remove a protective film and paste on the hinge 13. A lock ring

Convex and persistent washers, installation position

1. A lock ring 2. A persistent washer 3. A convex washer

Removal and installation the SHRUS

PERFORMANCE ORDER

1) tighten a clip 2) at installation the cover can be pressed that further at car operation can lead to occurrence of folds; After installation for a second slightly open the end of a cover with smaller diameter to level pressure inside and outside, such ventilation of a cover will prevent occurrence of folds 3) clamp полуось in a vice 4) remove a cover 5) twist the special tool while the SHRUS will not be removed from a semiaxis 6) remove a lock ring internal the SHRUS 7) remove an internal SHRUS 8) establish the hinge against the stop 9) establish a lock ring 10) establish a convex washer 11) note position