Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
- Routine maintenance
   + Weekly checks
   - Car routine maintenance - petrol models
      Regular service
      Replacement of impellent oil and the oil filter
      Check of a condition of hoses, and revealing of sources of leaks
      Check of adjustment of coupling
      Check of level ATF
      Suspension bracket and steering drive
      Check of a condition of protective covers of power shafts
      Reading of memory of the block of self-diagnostics
      Replacement of the dust removal filter (model with К/В)
      Check of a condition of a coolant of a central air of air
      Replacement of spark plugs
      Check of a condition of system of ignition
      Check and adjustment of turns and quality of a mix of idling
      Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases
      Check of a condition and replacement of a belt of a drive of auxiliary units
      Greasing of the mechanism of a drive of deenergizing of coupling
      Condition check колодок brake mechanisms of forward and back wheels
      Check of serviceability of functioning and adjustment of a lay brake
      Trial runs
      Replacement трансмиссионной liquids АТ
      Greasing of locks and loops
      Replacement of a filtering element of an air cleaner
      Level check трансмиссионного oils (models with РКПП)
      Replacement of the fuel filter
      Replacement of hydraulic liquid LHM and the returnable filter
      Check of a condition of brake supports, disks and hydraulic hoses
      Replacement of a belt of drive ГРМ
      Replacement of a cooling liquid
   + Car routine maintenance - diesel models
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes

Car routine maintenance - petrol models

The routine maintenance schedule

Intervals of routine maintenance of the car offered in the present section are calculated on independent performance of all procedures by the owner of a vehicle. Duration of intervals was defined proceeding from a condition of daily operation of the car. Constantly to support a vehicle in peak the forms some of procedures at will of the owner can be carried out in more intensive mode. Composers of the present Management are assured that receptions from the power unit of the car and its other knots and systems of the maximum return can achieve only under condition of a conscientious attitude of the owner to care of the vehicle. It is not necessary to forget as well about maintenance of a trade dress of the car on a case of its resale.

At operation of the car in the conditions of strongly dusty district, frequent towage of the trailer or constant moving in an intense city cycle, intervals of performance of procedures of routine maintenance should be whenever possible reduced to a minimum.

Servicing of a new vehicle should be made in the conditions of a workshop of the service-centre of the trade mission of the company-manufacturer of the car in order to avoid infringement of factory guarantee certificates.

Through each 400 km (250 miles) run or once a week

•  Weekly checks See.

Through each 15 000 km (9000 miles) run or times in 12 months (that will come earlier)

•  Make replacement of impellent oil and the oil filter (Replacement of impellent oil and the oil filter see).
•  Check all components located in an impellent compartment and hoses on presence of traces of leaks (Check of a condition of hoses, and revealing of sources of leaks see).
•  Make check/updating of height of a pedal of coupling (Check of adjustment of coupling see).
•  Check level ATF, in case of need make corresponding updating (Check of level ATF see).
•  Check a condition and reliability of fastening of components of a suspension bracket and a steering drive (the Suspension bracket and a steering drive see).
•  Check a condition of rubber protective covers of power shafts (Check of a condition of protective covers of power shafts see).
•  Make the data read-out, brought in memory of the block of self-diagnostics (Reading of memory of the block of self-diagnostics see).
•  On the models equipped К/В, make replacement of the dust removal filter (Replacement of the dust removal filter (model with К/В see)).

Through each 30 000 km (18 000 miles) run

In addition to the checks listed in the previous subsection:
•  At a corresponding complete set check a condition of a coolant of a central air of air (Check of a condition of a coolant of a central air of air see).
•  Make replacement of spark plugs (Replacement of spark plugs see).
•  Check ignition system (Check of a condition of system of ignition see).
•  Check adjustment of turns and quality of a mix of idling (Check and adjustment of turns and quality of a mix of idling see).
•  Check a condition of components and connecting hoses of system of decrease in toxicity of the fulfilled gases (Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases see).
•  Check a condition of a belt of a drive of auxiliary units, in case of need make its replacement (Check of a condition and replacement of a belt of a drive of auxiliary units see).
•  Grease the mechanism of management with a coupling drive (Greasing of the mechanism of a drive of deenergizing of coupling see).
•  Check a condition колодок brake mechanisms of forward and back wheels (condition Check колодок brake mechanisms of forward and back wheels see).
•  Check serviceability of functioning of a lay brake (Check of serviceability of functioning and adjustment of a lay brake see).
•  Make car trial runs (Trial runs see).

Through each 45 000 km (27 000 miles) run

In addition to the checks listed in the previous subsection:
•  Make replacement ATF (Replacement трансмиссионной liquids АТ see).

Through each 60 000 km (36 000 miles) run

In addition to the checks listed in the previous subsection:
•  Grease door loops and locks (Greasing of locks and loops see).
•  Make replacement of the air filter (Replacement of a filtering element of an air cleaner see).
•  Check level трансмиссионного oils РКПП, in case of need make updating (level Check трансмиссионного oils (models with РКПП see)).
•  Make replacement of the fuel filter (Replacement of the fuel filter see).
•  Make replacement of hydraulic liquid LHM and returnable filters (Replacement of hydraulic liquid LHM and the returnable filter see).
•  Make check of a condition and, in case of need, replacement of a belt of a drive of auxiliary units on models with manual adjustment of a tension of a belt (Check of a condition and replacement of a belt of a drive of auxiliary units see).
•  Check a condition of supports, disks and hydraulic hoses of brake mechanisms (Check of a condition of brake supports, disks and hydraulic hoses see).
•  Make replacement of a belt of drive ГРМ (Replacement of a belt of drive ГРМ see).

In spite of the fact that according to the schedule of routine maintenance replacement газораспределительного a belt should be made through each 120 000 km (72 000 miles) run, composers of the present Management recommend to cut this interval by half for the cars maintained in the conditions of raised intensity. Remember that the damages of the engine connected with an exit of a belt out of operation in an operating time can lead to incommensurably big expenses!

Through each 120 000 km (72 000 miles) run

In addition to the checks listed in the previous subsection:
•  Make replacement of a belt of drive ГРМ (Replacement of a belt of drive ГРМ see) - the remark above see.
•  Make check of a condition and, in case of need, replacement of a belt of a drive of auxiliary units on models with automatic adjustment of a tension of a belt (Check of a condition and replacement of a belt of a drive of auxiliary units see).

Time in two years (without dependence from run size)

•  Make replacement of a cooling liquid (Replacement of a cooling liquid see).

Kind of an impellent compartment of models Xantia of 1995 of 1.8 l вып.

1 — a gas Cable
2 — the Cover of a jellied mouth of impellent oil
3 — an air cleaner Casing
4 — ShChup of measurement of level of impellent oil
5 — ВВ the ignition coil
6 — a heater Hose
7 — the Indicator of level of hydraulic liquid LHM
8 — the Tank of hydraulic liquid LHM
9 — the Receiver of the tank of hydraulic liquid LHM
10 — the Cover of the assembly block of safety locks/relays

11 — a thermostat Casing
12 — the Battery
13 — the Lever of deenergizing of coupling
14 — the Coal adsorber of system of catching of fuel evaporations
15 — the Oil filter
16 — the Generator
17 — the Belt of a drive of auxiliary units
18 — the Cover of a jellied mouth of a cooling liquid
19 — Cover ECU of injection of fuel
20 — the Cover of a jellied mouth of the tank of a liquid of washing of glasses

Kind of an impellent compartment of models Xantia SX of 1995 of 2.0 l вып.

1 — a gas Cable
2 — the Regulator of pressure of fuel
3 — the Cover of a jellied mouth of impellent oil
4 — an air cleaner Casing
5 — ВВ the ignition coil
6 — a heater Hose
7 — the Indicator of level of hydraulic liquid LHM
8 — the Tank of hydraulic liquid LHM
9 — the Receiver of the tank of hydraulic liquid LHM
10 — the Cover of the assembly block of safety locks/relays

11 — a thermostat Casing
12 — the Battery
13 — the Lever of deenergizing of coupling
14 — the Coal adsorber of system of catching of fuel evaporations
15 — the Oil filter
16 — the Generator
17 — the Belt of a drive of auxiliary units
18 — the Cover of a jellied mouth of a cooling liquid
19 — Cover ECU of injection of fuel
20 — the Cover of a jellied mouth of the tank of a liquid of washing of glasses

The bottom view on car Citroyon Xantia redock (all models)

1 — the Drain stopper of the pallet картера the engine
2 — Intermediate section of the right power shaft
3 — the Receiver of the tank of hydraulic liquid LHM
4 — the Support of the brake mechanism
5 — the Bottom lever of a forward suspension bracket
6 — Steering draught

7 — the Drain stopper картера РКПП
8 — the Steering mechanism
9 — the Pipe of system of release of the fulfilled gases
10 — the Forward stabilizer of cross-section stability
11 — the Back support of the power unit
12 — the Pump of hydraulic system LHM

The typical bottom view on car Citroyon Xantia back (all models)

1 — the Fuel tank
2 — the Proof-reader of height of a back suspension bracket
3 — the Connecting bar of a back suspension bracket
4 — the Stabilizer of cross-section stability
5 — Fuel and brake lines

6 — the Hydraulic block of a back suspension bracket
7 — the Longitudinal lever of a back suspension bracket
8 — the Receiver of the tank of hydraulic liquid LHM
9 — the Muffler with an exhaust pipe
10 — the Holder of a spare wheel

The general information

The given Chapter was made to help on purpose to the owner of the car to support the vehicle in a condition of the maximum readiness for operation, receiving from it effective return with observance of requirements to profitability and safety.

In the beginning of the Head the schedule of routine maintenance of the car is resulted. The sections devoted to a detailed statement of an order of performance by each of procedures of service separately are more low offered. Descriptions of visual checks, adjustments, procedures of removal and installation of components are included in a material of sections, and also a various good advice and recommendations. Resulted above an illustration with the image of kinds of an impellent compartment, suspension brackets and a steering will help the reader to understand with placing on the car of components subject to service.

Serving the car according to the kilometrazhno-time schedule, and following the detailed recommendations resulted more low, the reader will receive the accurate program of the actions, capable to provide long duration and reliability of service of its vehicle. Remember that the given program is made on a complex basis and performance of its only separate points with neglect others will not lead to desirable result.
In process of performance of service of the car the reader will soon be convinced that many procedures can, and should, to be united in the general groups in view of similarity of the nature or affinity of an arrangement of components. For example, if the car for any reason is lifted over the earth, it is necessary to take advantage of a case and at the same time to check up a condition of components of system of release of the fulfilled gases, a suspension bracket and a steering.

The first step in vehicle service always is self-preparation of the executor of works. Attentively familiarise with a material of the present Chapter, then make the list of components requiring attention, prepare the necessary tool and outline the short plan of forthcoming works. In case of occurrence resistant to resolution of problems address for the help to experts of car-care centre.

 


On the main page