Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
- Coupling
   Adjustment of a drive of coupling
   Removal and installation of a cable of a drive of coupling
   Removal and installation of a pedal of coupling
   Removal, check of a condition and installation of assemblage of coupling
   Removal, check of a condition of components and installation of the mechanism of deenergizing of coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Adjustment of a drive of coupling


The general scheme of adjustment of a cable of a drive of coupling

1 — the Counternut
2 — the Adjusting nut

And — the Working course of a pedal of coupling
In — the Free wheeling of a pedal of coupling

Correctness of adjustment of a drive of coupling is checked by measurement of size of a working course of its pedal. After replacement drive its cable усадка it is made during not less than thirty squeezings of a pedal of coupling.

 PERFORMANCE ORDER

1. Make sure that nothing has got under a coupling pedal, then measure distance of the central part of its overlay to the steering wheel basis (the pedal should be completely released) now squeeze out a pedal against the stop and repeat measurement.
2. For definition of size of a course of a pedal subtract result of the first measurement from result of the second. Compare the received value to requirements of Specifications. In case of need make corresponding updating (see further).
3. Adjustment drive a cable is made by отпускания adjusting райки on the end of a cable turned to transmission (the General scheme of adjustment of a cable of a drive of coupling see an illustration). On some models access to a counternut is limited, in this connection it is necessary to remove preliminary a sleeve of an air cleaner or components of its casing (see the Head of the Power supply system and release).

4. In an impellent compartment ослабьте a counternut on the end of a cable of a drive of coupling turned to transmission. Modify position of an adjusting nut, then squeeze out a pedal of coupling ten times and repeat measurement of size of its course. Continue to operate in the same order until will achieve demanded result.

5. Make sure that the size of a free wheeling of a pedal (the General scheme of adjustment of a cable of a drive of coupling see an illustration) does not exceed 60 mm for what measure distance from an overlay of the released pedal to the steering wheel basis, then lift a pedal and repeat measurement; subtract from result of the first measurement result of the second.
6. Having finished adjustment, tighten a counternut on the end drive a cable. Establish components of an air cleaner acting in film for the purpose of providing of access (see the Head of the Power supply system and release).


On the main page