Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
- Coupling
   Adjustment of a drive of coupling
   Removal and installation of a cable of a drive of coupling
   Removal and installation of a pedal of coupling
   Removal, check of a condition and installation of assemblage of coupling
   Removal, check of a condition of components and installation of the mechanism of deenergizing of coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes

Removal and installation of a cable of a drive of coupling

Removal

 PERFORMANCE ORDER

1. In case of need for the purpose of providing of access remove an air cleaner sleeve, or components of its casing (see the Head of the Power supply system and release). Also in case of need remove the storage battery with the pallet and a basic arm (start and charge Systems see).
2. On models with a link sided steering remove the tank of a hydraulic liquid (the Uniform hydraulic system see the Head) and lay it in suitable capacity.

3. In an impellent compartment completely ослабьте a counternut, then an adjusting nut on the end turned to transmission drive a cable, then liberate assemblage of a cable from картера transmissions.





4. Access to a coupling pedal in car salon is extremely limited, therefore composers of the present Management recommend to remove the panel of devices preliminary. Basically, will enough remove only bottom panel of a felt upholstery.

5. By means of a screw-driver release a plastic clamp at once under the top part of a pedal of coupling and disconnect a cable from a pedal.

6. Return to an impellent compartment and liberate directing a cable from a partition of an impellent compartment. Having pulled a cable forward, liberate it from the remained clamps and directing. Try to remember a route of a lining of a cable, then take it from an impellent compartment.

7. Attentively examine a cable on presence of traces of damage of a cover and deterioration of tips. Estimate a core condition. Make sure of serviceability of functioning тросовой assemblages. The core should slide freely in a cover. Remember that cable regularly functioning out of the car can give out refusals after its installation in regular position. In case of revealing of the slightest defects or deterioration signs make replacement тросовой assemblages.

Installation

 PERFORMANCE ORDER

1. Grease clamps of tips with universal greasing, then pass a cable through a partition of an impellent compartment.



2. Having enclosed under a pedal approaching on the size wooden брусок or the tool, fix a coupling pedal in the released position (in the end of a working course).

3. Fill a cable tip in a plastic clip and track reliability of its fixing.

For simplification of landing of a tip in a clamp ask the assistant to wring out the cable core for a tip from outside transmissions.

4. In an impellent compartment fill a cable in картер transmissions and connect it to the lever of deenergizing of coupling. Screw adjusting and контрящую nuts.
5. Execute cable adjustment (Adjustment of a drive of coupling see) and make sure of serviceability of functioning of a pedal of coupling.
6. Establish into place a felt upholstery, or the panel of devices, and on models with a link sided steering also the tank of a hydraulic liquid (the Uniform hydraulic system see the Head).
7. Establish the battery and components воздухозаборного a path.



On the main page