Citroen Xantia

1. If the power unit is not removed from the car for the purpose of major repairs performance (engine Repair see the Head), access to the mechanism of deenergizing of coupling can be provided by removal only transmissions (the Manual box of a gear change see).
2. On models with coupling usual (выжимного) type liberate выжимной the bearing from a plug of deenergizing and remove it from a pin of primary shaft РКПП. Beat out a cylindrical finger and remove the lever of deenergizing of coupling from the top part of an axis of a plug. The finger at assemblage is subject to replacement without fail.
3. On couplings of both types wring out fixing uvulas and remove the top plug from the end of an axis of a plug of deenergizing. Take out an axis from the bottom plug and take it from transmission. Wring out lock uvulas and take the bottom axial plug from картера transmissions.

1. Estimate degree of deterioration of all components of the mechanism of deenergizing of coupling. Defective details replace. It is necessary to give special attention to a condition подшипниковых, persistent and contact surfaces.
2. At condition check выжимного the bearing it is necessary to remember that a good form rule is replacement of the given major component without fail. Check up smoothness of contact surfaces of the bearing, estimate freedom of its rotation. In the presence of the slightest doubts replace the bearing (models with coupling of exhaust type in gathering with a basket - are see by Removal, check of a condition and installation of assemblage of coupling).

1. Grease axial plugs and contact surfaces of a plug of deenergizing of coupling with greasing on a basis дисульфида molybdenum.

2. Fill in картер РКПП the bottom axial plug, having tracked reliability of fixing by its lock uvulas.

3. Establish a deenergizing plug.

4. Put on a plug axis the top plug, having latched it on the seat in картере transmissions.

5. On models with coupling usual (выжимного) type dress on an axis of a plug the deenergizing lever. Level the lever concerning an aperture in an axis and fix its new cylindrical finger. Plant выжимной the bearing on a pin of a primary shaft and enter it into gearing with a deenergizing plug.
6. Establish into place transmission assemblage (the Manual box of a gear change see).