Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
- 10. Transmissions and power shafts
+ 10.1. A mechanical transmission
- 10.2. An automatic transmission
10.2.1. A technical characteristics
10.2.2. Removal, installation and adjustment of a cable of the device kick-down
10.2.3. Removal, installation and adjustment of a cable of a choice of transfers
10.2.4. Replacement of the switch of blocking of a starter and backing lanterns
+ 10.2.5. A transmission
+ 10.3. Power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes
|
Elements of fastening of a cable to the selector lever
|
|
And – a clip,
In – the plug |
Removal
| PERFORMANCE ORDER |
| 1. Remove a wire of weight from the accumulator. |
| 2. Release the selector lever for what unscrew and move back the central console, then disconnect decorative furnish from the central console and the selector lever. |
| 3. Remove the holder of a bulb. |
| 4. Disconnect a cable and a cover of a cable from the selector lever. |
| 5. Remove a lock ring and disconnect a cable from a transmission. |
|
6. Take a cover of a cable from an arm (And – скоба cable fastenings, In – an arm of fastening of a cover of a cable). |
| 7. In car salon adhere to the cable end a thin long cord which is required for cable installation into place. |
| 8. Take a cable in a motor compartment and untie from it a cord, having left it on a place. |
|
Installation and adjustment
| PERFORMANCE ORDER |
| 1. At installation of a new cable establish the lever of a choice of transfers on a transmission and the selector lever in River position |
| 2. Establish a cable so that it has not been strongly tense, but at the same time and did not sag. |
| 3. Check up that the selector lever moves to all positions and thus the lever of a choice of transfers on a transmission is combined with a corresponding clamp. |
| 4. If necessary adjust length of a cable from outside the central console. |
| 5. The further installation is made in sequence, return to removal. |
|
|
On the main page
|