Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
- 10. Transmissions and power shafts
   + 10.1. A mechanical transmission
   - 10.2. An automatic transmission
      10.2.1. A technical characteristics
      10.2.2. Removal, installation and adjustment of a cable of the device kick-down
      10.2.3. Removal, installation and adjustment of a cable of a choice of transfers
      10.2.4. Replacement of the switch of blocking of a starter and backing lanterns
      - 10.2.5. A transmission
         10.2.5.1. Removal automatic gearbox
         10.2.5.2. Installation automatic gearbox
         10.2.5.3. Major repairs of an automatic transmission
   + 10.3. Power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





10.2.5. A transmission

10.2.5.1. Removal automatic gearbox
PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Remove the air filter.
3. Disconnect the tyre of grounding from a face cover of a transmission.
4. Disconnect a cable of compulsory inclusion of a hill-climbing gear from the carburettor, then unscrew bolts, fastening a cable to a transmission.
5. Remove a cable of a choice of transfers from the lever on a transmission, then unscrew bolts of fastening of an arm of a cable. It is not required to remove a cable from an arm.
6. Disconnect a cable of a drive of a speedometer from a transmission.
7. Unscrew three top bolts, крепящих a transmission to the engine. Keep in mind that the central bolt also крепит an arm supporting a tube of system of cooling.
8. Loosen the bolts of fastening of forward wheels, then lift a forward part of the car and fix on supports.
9. Remove forward wheels.
10. Using the load-lifting mechanism, support the engine.
11. Disconnect spherical hinges of the bottom levers of a forward suspension bracket.
12. Disconnect power shafts from a transmission.
13. Using a soft wire, adhere the internal ends of power shafts to a body.
14. Close apertures in a transmission suitable stoppers.
15. Disconnect from a transmission giving hoses трансмиссионной liquids to a radiator.
16. Unscrew bolts, fastening a protective plate of a transmission, then note mutual position of the hydrotransformer and a drive plate.
17. A wrench for a bolt of fastening of a pulley of a cranked shaft turn a cranked shaft of the engine in such position that one of bolts of fastening of the hydrotransformer was accessible.
18. A screw-driver or mount for teeths of a gear wreath fix a plate of a drive from проворачивания and unscrew a bolt of fastening of the hydrotransformer.
19. Turn a cranked shaft of the engine and similarly unscrew the remained bolts.
20. Unscrew the remained bolts of fastening of a transmission to the engine.
21. Unscrew bolts of fastening of a back support of the power unit to a body.
22. Unscrew bolts of fastening of an arm of support of an exhaust system.
23. A jack through wooden брусок support a transmission.
24. Remove the left support of the power unit.
25. Unscrew two bolts, fastening a transmission to an engine arm.
26. Take away a transmission from the engine, then lower and take it from under the car.
27. If transmission removal is interfered by a tube for probeа measurements of level of oil, remove it.
28. If the transmission is subject to replacement, rearrange on a new transmission a support of the power unit and connecting муфты an oil radiator.

On the main page