Opel Kadett E

1984-1991 of release

Repair and car operation

9.2.1. Adjustment of a cable of coupling

THE GENERAL DATA

---

The prevention

In 1989 a part of cars have been made with height of installation of a pedal of a brake on 15 mm above a coupling pedal. Normal installation of a pedal of a brake on 4 mm below a coupling pedal. If necessary adjust height of installation of a pedal of a brake for what change length of a pusher of the vacuum amplifier of brakes, rotating a plug on a pusher.

---

PERFORMANCE ORDER

1. At replacement of coupling or a coupling cable it is necessary to make initial adjustment of a cable of coupling. 2. Using a roulette, measure distance And from the centre of a rubber overlay of a pedal of coupling to a steering wheel in a starting position of a pedal of coupling and write down the measured value. 3. Press a coupling pedal against the stop and spend similar measurement (distance). 4. Define a course of a pedal of coupling for what subtract the first measurement from the second. The course of a pedal of coupling should correspond to technical requirements. 5. Otherwise adjust length of a cable of coupling as follows. 6. In a motor compartment remove скобу, крепящую a carving tip of a cable of coupling to the squeezing lever and rotating a regulator, adjust a coupling cable. Regulator rotation clockwise increases a pedal course, and counter-clockwise – reduces it. 7. Make repeated measurement of a course of a pedal and establish скобу, fixing a carving tip of a cable of coupling. 8. If coupling is maintained long time, probably, adjustment of a cable of coupling will not give result. It testifies to deterioration of frictional overlays of a disk of coupling and necessity of replacement of a disk of coupling.