Opel Kadett E

1984-1991 of release

Repair and car operation

9.2.2. Removal and installation of a cable of coupling

PERFORMANCE ORDER

1. In a motor compartment measure length of a carving tip of a cable of the coupling, acting of the squeezing lever. This size is necessary for using for maintenance of correct installation of a cable of coupling. 2. Remove скобу, крепящую a carving tip of a cable of coupling to the squeezing lever, and remove from the lever a carving tip. For simplification of removal move the lever to the engine. 3. Remove fastening of a cover of a cable of coupling from ledges on картере couplings. 4. In car salon remove the bottom panel of furnish in deepening for feet of the driver, then disconnect a returnable spring from a pedal of coupling and remove a cable of coupling from a coupling pedal. Keep in mind that a returnable spring also крепит to a pedal of coupling a coupling cable (And – a place of fastening of a cable of coupling by a returnable spring). 5. For access improvement it is recommended to remove a coupling pedal. 6. Through a partition of a motor compartment take a coupling cable in a motor compartment. Thus do not damage a sealing ring of a partition of a motor compartment. 7. Installation is made in sequence, return to removal. 8. Establish a carving tip of a cable of coupling so that it выступание from the squeezing lever was same, as well as before removal. 9. Check up correctness of an arrangement of a sealing ring in a partition of a motor compartment.