Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
- 10. A body
   10.1. Maintenance service and body repair
   10.2. Vinyl furnish
   10.3. An upholstery and rugs
   + 10.4. Repair of insignificant damages of a body
   10.5. Repair of considerable damages of a body
   10.6. Loops and locks
   10.7. A windscreen and motionless glasses
   10.8. A cowl
   10.9. A latch of the lock of a cowl and a cable
   10.10. A forward lattice
   10.11. Bumpers
   10.12. The facing panel of a door
   10.13. An external mirror
   10.14. A door
   10.15. A forward wing
   10.16. A door of a cargo compartment
   10.17. Glass of a door of a cargo compartment and window lifter
   + 10.18. Glasses of doors
   10.19. Стеклоподъемник
   10.20. A lock clamp, the switch of the lock and door handles
   10.21. A casing of a steering column
   10.22. The central floor section
   10.23. Panels of forward facing of salon
   10.24. The panel of forward facing of salon
   10.25. An air inlet lattice
   10.26. Seats
+ 11. An electric equipment
+ 12. Electroschemes

10.12. The facing panel of a door

Removal and installation

PERFORMANCE ORDER
1. In the cars equipped with the electric drive of windows, disconnect the battery from weight.
2. Remove the handle window lifterа (on а/м without the electric drive). For this purpose get under the handle a cord and get a lock ring, with force having pulled for the cord ends (to pull in a direction specified by arrows).
3. Remove the handle from a shaft window lifterа.
4. Take заглушки, turn out 2 screws (are specified by arrows) and remove an armrest.
5. Turn away the screw of the internal handle.
6. Displace the handle forward and get from facing.
7. Unhook the handle from draught.
8. Remove the switch window lifterа, cautiously having hooked the panel and having disconnected a socket.
9. Turn away the fastening screw under a mirror.
10. Turn away screws from the top back party of facing of a door (1–8 latches).
11. Remove mirror facing (if it is provided) and cautiously take 8 latches крепящих door facing.
12. For a detachment of latches insert the tool between a skeleton and facing.
13. Facing of a back door fastens 2 latches on forward and back end faces of a door, 2 screws in an average part and 7 latches on facing edge.
14. For access to door mechanisms cautiously remove a water filter.
15. For screen removal get two condensing plugs (are specified by arrows).
16. If the screen at removal is damaged, stick anguishes with a sticky tape or replace. Track safety of consolidation on a screen contour.
17. Installation is carried out upside-down.
18. Track that all screws of facing have been wrapped and all latches are inserted.
19. If the screen does not stick to a door in separate places on a contour slightly grease these places with silicone hermetic.


On the main page