Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
- 10. A body
   10.1. Maintenance service and body repair
   10.2. Vinyl furnish
   10.3. An upholstery and rugs
   + 10.4. Repair of insignificant damages of a body
   10.5. Repair of considerable damages of a body
   10.6. Loops and locks
   10.7. A windscreen and motionless glasses
   10.8. A cowl
   10.9. A latch of the lock of a cowl and a cable
   10.10. A forward lattice
   10.11. Bumpers
   10.12. The facing panel of a door
   10.13. An external mirror
   10.14. A door
   10.15. A forward wing
   10.16. A door of a cargo compartment
   10.17. Glass of a door of a cargo compartment and window lifter
   + 10.18. Glasses of doors
   10.19. Стеклоподъемник
   10.20. A lock clamp, the switch of the lock and door handles
   10.21. A casing of a steering column
   10.22. The central floor section
   10.23. Panels of forward facing of salon
   10.24. The panel of forward facing of salon
   10.25. An air inlet lattice
   10.26. Seats
+ 11. An electric equipment
+ 12. Electroschemes
трубы купить

10.15. A forward wing

Removal and installation

1. Lift redock of the car and remove a wheel.
2. Remove turn indexes.
3. Disconnect all devices of illumination which can prevent wing removal.
4. Remove a forward lattice if it are built in обечайки illumination devices, or remove the bottom facing of headlights.
5. Remove protective panels of wheel niches for what it is necessary to turn away screws and to disconnect latches and скобы.
6. Turn away bolts of fastening of the top edge of a wing.
7. Open a door and turn away a bolt of fastening of the top back corner of a wing (it is specified by an arrow).
8. Turn away a bolt of the bottom back edge of a wing which is directly behind a wheel niche (it is specified by an arrow).
9. Cautiously remove a wing (it is recommended to operate together).
10. If the wing varies, remove a decorative overlay of an edge of a wheel niche.
11. For this purpose turn away 5 bolts, get 6 latches and drill 2 rivets. Rivets drill a drill, having wound it in 10 mm from top.
12. Installation is carried out upside-down.

On the main page