Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation



Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
- 10. A body
   10.1. Maintenance service and body repair
   10.2. Vinyl furnish
   10.3. An upholstery and rugs
   + 10.4. Repair of insignificant damages of a body
   10.5. Repair of considerable damages of a body
   10.6. Loops and locks
   10.7. A windscreen and motionless glasses
   10.8. A cowl
   10.9. A latch of the lock of a cowl and a cable
   10.10. A forward lattice
   10.11. Bumpers
   10.12. The facing panel of a door
   10.13. An external mirror
   10.14. A door
   10.15. A forward wing
   10.16. A door of a cargo compartment
   10.17. Glass of a door of a cargo compartment and window lifter
   + 10.18. Glasses of doors
   10.19. Стеклоподъемник
   10.20. A lock clamp, the switch of the lock and door handles
   10.21. A casing of a steering column
   10.22. The central floor section
   10.23. Panels of forward facing of salon
   10.24. The panel of forward facing of salon
   10.25. An air inlet lattice
   10.26. Seats
+ 11. An electric equipment
+ 12. Electroschemes





10.9. A latch of the lock of a cowl and a cable

Removal and installation


The prevention

Take the measures excluding operation of a pillow of safety (subsection 11.44 see).


PERFORMANCE ORDER
1. Remove a forward lattice.
2. Outline a latch contour on a rack of a radiator and turn away fastening bolts (are specified by arrows).
3. Take away a latch of a cowl and unhook a cable (the forward lattice is removed).
4. Installation is carried out upside-down.
5. At not tightened bolts adjust position of a latch and tighten bolts.
6. For cable replacement disconnect скобы and latches on its all line пролегания.
7. Remove the bottom facing panel, get the lever of a cable from the forward panel and turn away screws of fastening (arrow).
8. Hook and get a cable from an arm and unhook from the lever.
9. Fix on the cable end from outside salon a thin wire and extend a cable in a motor compartment.
10. Installation is carried out upside-down.

On the main page