Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
- 10. Brake system
   10.1. Technical characteristics
   10.2. Adjustment of position of a pedal of a brake
   10.3. The main cylinder of a brake
   10.4. The brake mechanism of a forward wheel of mark Teves
   10.5. The brake mechanism of a forward wheel of mark GIRLING
   10.6. A brake disk
   10.7. The case скобы and the piston
   10.8. The drum-type brake mechanism of a back wheel
   10.9. A brake drum
   10.10. The wheel brake cylinder
   10.11. The disk brake mechanism of a back wheel
   10.12. A pressure regulator
   - 10.13. A lay brake
      10.13.1. Adjustment of a lay brake
   10.14. Antiblocking system of brakes (ABS)
   10.15. Prorolling of brake system
+ 11. A body
+ 12. An electric equipment

10.13. A lay brake
THE GENERAL DATA

Lay brake

1 – the longitudinal lever of a back suspension bracket;
2 – a clip;
3 – an adjusting nut;
4 – the equalizer;
5 – a protective cover;
6 – an arm;
7 – an axis;
8 – a lock ring;
9 – the switch of a control lamp of a lay brake;
10 – gear sector;
11 – the doggie;
12 – draught;
13 – a spring;
14 – the button;
15 – the handle;
16 – шплинт;
17 – a casing;
18 – an axis;
19 – draught of the equalizer;
20 – the plug;
21 – a lock ring;
22 – the holder;
23 – a sealant;
24 – a cable;
25 – the lever

Replacement of a cable of a drive of a lay brake (model with back drum-type brake mechanisms)

PERFORMANCE ORDER
1. To establish basic бруски under forward wheels.
2. To weaken an inhaling of bolts of fastening of a back wheel.
3. To raise and establish on support a back part of the car.
4. To remove a wheel.
5. To remove back brake колодку and to disconnect a tip of a cable from drive the lever (fig. the Drum-type brake mechanism of a back wheel see).
6. To weaken an adjusting nut and to disconnect a cable from the equalizer.
7. To disconnect the holder from the longitudinal lever and to remove a cable, having taken out from the longitudinal lever a sealant.
8. To establish a new cable upside-down.
9. After installation to adjust a lay brake.


On the main page