Audi 100

1982-1990 of release

Repair and car operation

Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
- 10. Brake system
   10.1. Technical characteristics
   10.2. Adjustment of position of a pedal of a brake
   10.3. The main cylinder of a brake
   10.4. The brake mechanism of a forward wheel of mark Teves
   10.5. The brake mechanism of a forward wheel of mark GIRLING
   10.6. A brake disk
   10.7. The case скобы and the piston
   10.8. The drum-type brake mechanism of a back wheel
   10.9. A brake drum
   10.10. The wheel brake cylinder
   10.11. The disk brake mechanism of a back wheel
   10.12. A pressure regulator
   + 10.13. A lay brake
   10.14. Antiblocking system of brakes (ABS)
   10.15. Prorolling of brake system
+ 11. A body
+ 12. An electric equipment

10.3. The main cylinder of a brake

THE GENERAL DATA

The main brake cylinder

1 – the case;

2 – the sealing plug;

3 – the union;

4 – a tank;

5 – the filter;

6 – a sealing ring;

7 – a cover;

8 – a rubber sealant;

9 – the pipeline;

10 – a bolt

Removal

PERFORMANCE ORDER

1. To disconnect a wire from "the minus" plug of the storage battery.

2. To clear of a dirt of a place of connection of pipelines to the main cylinder.

3. To disconnect wires from plugs of the gauge of level of the brake liquid established in a cover of a tank of the main cylinder and to uncover.

4. To turn away a nut of fastening and to disconnect pipelines from the case of the main cylinder of a brake. To muffle apertures of pipelines.

5. To turn away two bolts of fastening of the main cylinder to the vacuum amplifier and to remove the main cylinder of a brake with a tank. Thus to watch, that the rubber sealant of the cylinder has not dropped out.

6. To turn the main cylinder and to merge in capacity a brake liquid from a tank. Then some times to press the piston of the main cylinder, having removed thereby from it a liquid.

Installation

PERFORMANCE ORDER

The main cylinder in an order, the return to removal is established. After installation it is necessary to pump over brake system (subsection 10.15 see).

On the main page