Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
- 10. Brake system
10.1. Technical characteristics
10.2. Adjustment of position of a pedal of a brake
10.3. The main cylinder of a brake
10.4. The brake mechanism of a forward wheel of mark Teves
10.5. The brake mechanism of a forward wheel of mark GIRLING
10.6. A brake disk
10.7. The case скобы and the piston
10.8. The drum-type brake mechanism of a back wheel
10.9. A brake drum
10.10. The wheel brake cylinder
10.11. The disk brake mechanism of a back wheel
10.12. A pressure regulator
+ 10.13. A lay brake
10.14. Antiblocking system of brakes (ABS)
10.15. Prorolling of brake system
+ 11. A body
+ 12. An electric equipment
|
Check of a condition of working surfaces of a brake disk
| PERFORMANCE ORDER |
| 1. To raise a forward part of the car and to remove a wheel (subsection 10.4 see). |
| 2. To clear a brake disk. |
| 3. To measure by a calliper a thickness of a disk. Is minimum admissible thickness of a disk is specified in Technical characteristics. If a thickness of a disk of less admissible it is necessary to replace a disk. |
| 4. At presence рисок the disk can be removed and прошлифовать, but taking into account that its definitive thickness was not less admissible. It is recommended to replace brake disks from both parties. Face palpation of a working surface of a disk should be no more than 0,06 mm. |
|
The prevention Condition of working surfaces of a brake disk to check without removal of a disk from the car.
Removal and installation
| PERFORMANCE ORDER |
| 1. To raise a forward part of the car and to remove a wheel (subsection 10.4 see). |
| 2. To turn away two bolts of fastening, to remove brake скобу in gathering and to suspend it on a wire to a body, watching that the brake hose was not overwound and did not test excessive loadings. |
| 3. For convenience of the further installation brake скобы it is recommended to remove preliminary brake Pads (subsection 10.5 see). |
| 4. To remove a brake disk. |
| 5. To establish a brake disk upside-down. Before installation to clear interfaced surfaces of a nave of a wheel and a brake disk. To wrap two bolts of fastening brake скобы the moment 70 Н·м (7,0 кгс·м). After installation to press some times a pedal of a brake for piston installation into position. |
|
|
On the main page
|