Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
- 6. The power supply system
   - 6.1. The power supply system of carburettor engines
      6.1.1. Replacement of a filtering element of the air filter
      6.1.2. Removal and installation of the air filter
      6.1.3. Temperature regulator check
      6.1.4. Check of the valve of a temperature regulator
      6.1.5. Removal and installation of the fuel pump
      6.1.6. Check of pressure of forcing of the fuel pump
      6.1.7. Removal and installation of a cable of a drive of an accelerator
      6.1.8. Adjustment of a cable of a drive of an accelerator
      6.1.9. Replacement of the gauge of level of fuel
      6.1.10. Removal and installation of a fuel tank
      6.1.11. Replacement of the filter of thin clearing of fuel
      6.1.12. Removal and carburettor installation
      + 6.1.13. Dismantling and carburettor assemblage
      + 6.1.14. Carburettor Pierburg adjustments 1B3
      + 6.1.15. Carburettor Pierburg adjustments 2Е2
      + 6.1.16. Carburettor Keihin adjustments
   + 6.2. The power supply system of engines with fuel injection
   + 6.3. The power supply system of the diesel engine
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment


https://www.youtube.com/channel/UCoah5uA-uF-j35-MalVTfRQ


6.1.4. Check of the valve of a temperature regulator
THE GENERAL DATA

The temperature regulator valve (fig. the Air filter see) operates заслонкой. At the faulty valve there can be faults in engine work idling in a warming up mode, fault at increase in frequency of rotation, the engine develops insufficient capacity, the fuel expense increases. The valve check on the cold engine. Заслонка should turn easily, without jammings. On the warm engine depending on an ambient temperature access of warm air should be blocked partially or completely.

PERFORMANCE ORDER
1. To remove the filter, without disconnecting hoses (5) and (17).
2. To start the engine and to leave to idle.
3. To disconnect a hose from the valve. Заслонка should block giving of warm air.
4. To put on the valve a hose. Заслонка should open access to warm air.
5. To disconnect a hose. Заслонка should turn and block access to warm air. If it does not occur, the valve means is faulty.

On the main page