Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation

Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
- 10. Brake system
   10.1.2. Brake Pads forward brakes
   10.1.3. Brake Pads back brakes
   10.1.4. The general adjustment of back brakes (Girling)
   10.1.5. Replacement brake колодок (all-wheel drive models)
   10.1.6. The general adjustment of back brakes (Girling) (all-wheel drive models)
   10.1.7. Plugs of pedals of a brake and coupling
   10.1.8. Adjustment of a manual brake
   10.1.9. Removal of the lever of a manual brake
   - 10.2. Hydraulic components
      10.2.1. The hydraulic booster of brakes / the main brake cylinder
      10.2.2. Changes in hydraulic system
      10.2.3. The main brake cylinder / сервоцилиндр brake system
   + 10.3. Antiblocking system of brakes
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment

10.2.3. The main brake cylinder / сервоцилиндр brake system

THE GENERAL DATA

The prevention
Use only a new brake liquid. Establish a tank according to a mark in a tank of a brake liquid.

The main brake cylinder / сервоцилиндр brake system

1. A tank of a brake liquid
With the indicator of level of a brake liquid
2. Заглушка
Moisten in a brake liquid and establish in an aperture main торомозного the cylinder
Establish a tank of a brake liquid in apertures заглушек
3. The valve of an aperture of descent of air
Always pump over the main brake cylinder after installation removal /
Slightly grease a carving of the valve and an aperture with a liquid of the brake cylinder
4. The pipeline of brake system
5. The main brake cylinder
Diameter: 23.81 mm
7. The valve of an aperture of descent of air
Slightly grease a carving of the valve and an aperture with a brake liquid before installation
8. The distributive valve
It is not regulated
9. 25 Н.м.
11. 10 Н.м.
12. 20 Н.м.
13. An arm
14. The filter
15. A sealing ring
Establish on an arm before installation сервоцилиндра brake system then move to the panel of devices
16. 20 Н.м.
17. The pipeline of brake system
18. A sealing ring
Always replace
19. The extension piece
20. The alarm switch
The inhaling moment: 20 Н.м.
21. The return pipeline
22. The high pressure pipeline
Goes to the pressure accumulator
23. Сервоцилиндр
Do not press a brake pedal at the removed main brake cylinder
Check on tightness: at the switched off engine ослабьте connection of the return pipeline if сервоцилиндр it is not tight, it will pass a liquid (occurrence of rare drops is normal)
25. A plug
27. The panel of devices
28. 25 Н.м.
29. A pedal arm

Plug, adjustment

And = 226.0 (0.5 mm)

The plug should is at right angle to a surface сервоцилиндра at carrying out of measurements.

On the main page