Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation


Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
- 10. Brake system
   10.1.2. Brake Pads forward brakes
   10.1.3. Brake Pads back brakes
   10.1.4. The general adjustment of back brakes (Girling)
   10.1.5. Replacement brake колодок (all-wheel drive models)
   10.1.6. The general adjustment of back brakes (Girling) (all-wheel drive models)
   10.1.7. Plugs of pedals of a brake and coupling
   10.1.8. Adjustment of a manual brake
   10.1.9. Removal of the lever of a manual brake
   + 10.2. Hydraulic components
   - 10.3. Antiblocking system of brakes
      10.3.2. The hydraulic pump
      10.3.3. The electronic block of management
      - 10.3.4. Elements ABS of a forward wheel
         10.3.4.1. Gauges of speed of rotation of forward wheels
      + 10.3.5. Elements ABS of back brakes
      10.3.6. Broad-brush observations on repair
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment

10.3.4.1. Gauges of speed of rotation of forward wheels Cнятие

PERFORMANCE ORDER
1) remove a fastening bolt (it is specified by the bottom arrow) and get the gauge of speed
2) replace a sealing ring of the gauge
3) grease a sealing ring and the gauge of speed with the same greasing that was used for greasing of the mechanism of brakes
4) establish the gauge in a rack nest so that полихлорвиниловый the tip concerned a rotor on the SHRUS
5) establish a new fixing bolt and tighten it to 10 Н.м., keeping the gauge of speed, having pressed it to a rack of the bearing of a nave
6) insert the rubber plug of wires into an arm on a rack of the bearing of a nave (it is specified by the top arrow)

After the gauge of speed has been removed and established some times, replace old полихлорвиниловый a cap and establish new, a detail 437 927 809. It is necessary for maintenance of a demanded air backlash.

Plait of wires of the gauge of speed of a forward wheel, installation

PERFORMANCE ORDER
Put on a plait of wires the rubber plug (the top arrow) and stretch it to a rack of the bearing of a nave

Insert a plait of wires in the rubber plug into an arm on a body (the bottom arrow)

Fix burn down a wire by means of a clip in a point specified by an average arrow

The gauge of speed of the left forward wheel, detachment

PERFORMANCE ORDER
Remove a socket of connection from an arm (it is specified by an arrow) and disconnect it from the gauge

The gauge of speed of the right forward wheel, detachment

PERFORMANCE ORDER
ослабьте a fixing collar (it is specified by an arrow)

Remove a socket of connection and disconnect it from the gauge


On the main page