Audi A3

Since 1997 of release

Repair and car operation


Audi A3
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Manual box of a gear change
+ Automatic transmission and models with a full drive
- Coupling and power shafts
   + Coupling
   - Power shafts
      Removal and installation of power shafts
      Dismantling of a shaft of a drive
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electroschemes

Dismantling of a shaft of a drive

 Instructions on dismantling

PERFORMANCE ORDER
1. Remove a shaft and clamp it in a vice. Thus protect a shaft aluminium overlays.
2. Note an edge of a protective cover on a shaft that at assemblage a cover to put in its former position.
3. Cut бокорезами collars on both protective covers and remove them. Displace back a cover.
4. The external hinge: Remove the hinge strong blow of a hammer from easy metal from a shaft.
5. The internal hinge: Remove a lock ring corresponding nippers, for example, VW-161a or HAZET 2525K. Press the hinge on a press, thus bring a support under an internal nave of the hinge.
Instructions on assemblage
6. At installation of a protective cover on the case of the hinge the cover is often compressed. Therefore a cover on small diameter fill with air by means of a screw-driver.
7. Fill the hinge with greasing «AUDI G6.3». Half of greasing enter into a cover, other half in the hinge. The greasing total is resulted in Specifications.
8. The adaptation should be applied to a clip of collars (the alloyed steel) (HAZET 1847), shown on an illustration. Otherwise it will not be possible to create necessary effort of a clip. The adaptation put so that cutting elements of the adaptation settled down in corners (). In this position the screw () tighten динамометрическим a key the moment 25 Н m and thus pull a collar.
ATTENTION

The adaptation carving should have an easy course. Otherwise preliminary grease with its greasing MoS2.
On the main page








QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE