Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
- 10. Transmissions and power shafts
   + 10.1. A mechanical transmission
   - 10.2. An automatic transmission
      10.2.1. A technical characteristics
      10.2.2. Removal, installation and adjustment of a cable of the device kick-down
      10.2.3. Removal, installation and adjustment of a cable of a choice of transfers
      10.2.4. Replacement of the switch of blocking of a starter and backing lanterns
      - 10.2.5. A transmission
         10.2.5.1. Removal automatic gearbox
         10.2.5.2. Installation automatic gearbox
         10.2.5.3. Major repairs of an automatic transmission
   + 10.3. Power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





10.2.5.2. Installation automatic gearbox
PERFORMANCE ORDER
1. Installation is made in sequence, return to removal taking into account following moments.
2. If at removal from the hydrotransformer has flowed out трансмиссионная a liquid, fill in it to norm.
3. Wipe the hydrotransformer plug that at installation not to damage a sealing ring of an entrance shaft of a transmission, and check up that the hydrotransformer was correctly combined with pump shaft. For this purpose measure distance And which should make 9,0–10,0 mm.
4. Otherwise turn and press the hydrotransformer for its combination with pump shaft.
5. Put a greasing small amount on a basis дисульфида molybdenum on directing plug of the hydrotransformer and corresponding dredging in an end face of a cranked shaft.
6. Combine a colour label on the hydrotransformer with a white label on a plate of a drive and fix the hydrotransformer bolts. Keep in mind that bolts of fastening of the hydrotransformer are not tightened yet, between the hydrotransformer and a drive plate there will be a backlash equal of 0,4-1,5 mm.
7. Gradually and consistently tighten bolts of fastening of the hydrotransformer.
8. On transmissions with codes EF and ЕК, intended for work without an oil radiator do not remove заглушки with муфт connection of pipelines of an oil radiator.
9. Adjust a cable of a choice of transfers and a cable of compulsory inclusion of a hill-climbing gear.
10. Fill in in a transmission трансмиссионную a liquid.

On the main page