Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
- 2. Weekly checks and service in a way
   2.1. Check of tightness of connections
   2.2. If the engine is not started and the starter does not work
   2.3. If the engine is not started, even if the starter works normally
   2.4. Start from an external source (other car)
   2.5. Places of weekly checks
   2.6. Engine oil level
   2.7. Level of a cooling liquid
   2.8. Liquid level стеклоомывателя
   2.9. Level of a brake liquid
   2.10. Liquid level in system of a steering with the amplifier
   2.11. Electric system
   2.12. The accumulator
   2.13. Screen wiper brushes
   2.14. Tyres and pressure check in tyres
   2.15. Operational materials and liquids
   2.16. Pressure in tyres
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

2.4. Start from an external source (other car)
THE GENERAL DATA

At start from an external source observe following precautions:

 – Before connection of the external accumulator make sure that ignition is switched off;
 – Make sure that all electric equipment (headlights, heating devices, screen wipers etc.) are switched off;
 – Take into consideration all special precautions ordered on the accumulator;
 – Cars should not concern each other;
 – Make sure that the gear change lever is in neutral position (or PARK in case of an automatic transmission).


PERFORMANCE ORDER
1. Connect one end of a red wire of the big section to the positive plug of the discharged accumulator.
2. Connect other end of a red wire to the positive plug of the external accumulator.
3. Connect one end of a black wire of the big section to the negative plug of the external accumulator.
4. Connect other end of a black wire of the big section to the power unit or an element of a body of the started car far away from the accumulator.
5. Make sure that wires do not contact with the fan, приводными belts or other rotating parts of the car.
6. Start the engine, using an external source (thus the car-source engine should idle). After start of the engine of the car with the discharged accumulator disconnect wires in return sequence.


On the main page