Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
- 9. Coupling
   9.1. A technical characteristics
   + 9.2. A coupling cable
   9.3. Removal and installation of a pedal of coupling
   - 9.4. Coupling
      9.4.1. Coupling removal
      9.4.2. Coupling check
      9.4.3. Coupling installation
   9.5. Removal and installation выжимного the bearing
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





9.4.2. Coupling check
PERFORMANCE ORDER
1. Check up overlays of a disk of coupling on deterioration, mechanical damages or pollution by oil.
2. In the presence of these defects it is necessary to replace a coupling disk.
3. If frictional overlays in a good condition also are not worn out to grooves, springs демпфера are reliably fixed and заклепочные connections are not loosened, the coupling disk can be established in the car.
4. If the coupling disk is polluted by oil, check up the left oil sealing ring of a cranked shaft or a primary shaft of a transmission.
5. If necessary replace sealing rings before installation of a new disk of coupling.
6. Check up knot of a leading disk on deterioration of a press disk, mechanical damages, reliability заклепочного connections, damages диафрагменной coupling springs.
7. If the diaphragm spring is worn out or damaged, or there are suspicions that elasticity of a spring it is necessary to replace knot of a leading disk has changed.
8. Check up working surfaces of a press disk and a flywheel, interfaced to overlays of a disk of coupling. They should be pure, flat and not have scratches and development.
9. Check up press the bearing which should rotate easily, in regular intervals and silently. The working surface of the bearing influencing a press spring, should be smooth, without cracks, local corrosion or development.

On the main page