|
|
Subaru Legacy/Outback1999-2003 of releaseRepair and car operation |
|
|
Subaru Legasi, Autbek + Cars Subaru Legacy, Outback - The operation manual + Access, protection + Elements of systems of safety + The car equipment, arrangement of devices and controls + Comfort - Operation receptions The basic cautions Обкатка the new car Car refuelling The control of level of engine oil The control of level of a cooling liquid of the engine Transportation of cargoes in the car Engine start Engine stop Features of driving with a manual box of a gear change Features of driving with automatic transmission Features of management of the all-wheel drive car Features of operation of the car equipped with system of hydrostrengthening of a wheel (ГУР) Features of the driving, equipped противооткатным the device, - models with РКПП (at a corresponding complete set) Braking Features of the driving, equipped with system of dynamic stabilisation VDC (at a corresponding complete set) Control system of speed (темпостат) Electropneumatic suspension bracket (at a corresponding complete set) Automatic adjustment of height of position of a back suspension bracket (model Outback) Recommendations about economy of the expense of fuel Features of operation of the car equipped catalytic with the converter Car parking Recommendations about car driving in adverse weather conditions Operation of the car in the conditions of winter Trailer towage + Routine maintenance + The engine + Systems of cooling, heating + The power supply system and release + Engine electric equipment + Manual box and differential + Automatic transmission + Coupling + Brake system + Suspension bracket and steering + Body + Onboard electric equipment |
Engine start Cock a lay brake.At low temperature of air switch off all auxiliary consumers of electric energy to reduce loading by the storage battery. On equipped РКПП models squeeze out a coupling pedal against the stop and include neutral transfer. On models with АТ make sure that the selector lever is established in position «Р» or «N» and squeeze out a pedal of a foot brake. Without squeezing out a gas pedal, turn a key in the ignition lock in position «START» and include a starter. If the engine was not started at once, continue to scroll a cranked shaft a starter, remembering that duration of continuous functioning of a starter should not exceed 10 seconds. Repeated attempt of start should be made, having waited not less than 15 seconds, - the pause is necessary for cooling of the electromotor of a starter. If the engine does not manage to be started at continuous work of a starter within 10 seconds, or the started engine at once глохнет, try to execute start at the pedal of gas squeezed out to a half. After successful start of the engine release a gas pedal to avoid sharp increase of turns. If to start the engine still it is not possible, completely squeeze out a pedal of gas and keep it in the pressed position during all time of functioning of a starter, is will help to remove the superfluous fuel which has got to the inlet pipeline and cylinders of the engine. Duration of continuous work of a starter, as well as in the previous cases, should not exceed 10 seconds. If the engine is not started after a purge of cylinders, once again try to start it at partially squeezed out pedal of gas. Right after start realisation release a pedal. Features of start of the engine in cold weather in the conditions of high mountains (height more than 2400 m above sea level) At low temperature of air engine start is at a loss. In the conditions of high mountains where air is strongly discharged, engine start becomes complicated in addition. Instructions which is necessary for following at engine start in considered conditions are more low resulted. Switch off all auxiliary consumers of electric energy to reduce loading by the storage battery. Squeeze out to half pedal of gas and keep it in this position during all time прокручивания a cranked shaft of the engine a starter. Duration of continuous inclusion of a starter should not exceed 15 seconds. After realisation of successful start of the engine gradually release a gas pedal, without supposing substantial increase of turns. If the engine is not started, squeeze out a gas pedal against the stop and keep it in the pressed position during all time of functioning of a starter. Duration of continuous work of a starter, as well as in the previous case, should not exceed 10 seconds. If the engine still is not started, repeat attempt. At negative temperature of air or if the car was not used within several days, allow to the engine to get warm during 3 ÷ 4 minutes, only after that begin movement. |
On the main page |