Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
- Engine electric equipment
   Specifications
   Start of the engine from the auxiliary power supply
   Removal/installation, check and service of the storage battery
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information and safety measures
   Check of serviceability of functioning of system of ignition
   Removal, installation and check of a condition of the module (it) of ignition
   Check and adjustment of installation of a corner of an advancing of ignition
   Replacement of gauges CKP, CMP and KS
   Service and replacement of spark plugs
   Check of a condition of high-voltage wires (4-cylinder engines)
   Charge system - the general information and safety measures
   Check of a condition of system of a charge
   The generator - the general information, check and service
   Removal, dismantling, assemblage and generator installation
   Start system - the general information and safety measures
   Check of serviceability of functioning of a starter and start chain
   Starter Nippondenso - check and service
   Starters Mitsubishi - check and service
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Engine electric equipment

The general information

The structure of an electric equipment of the engine includes components of systems of ignition, a charge and start. Whereas the given systems have a direct bearing on engine work, they are considered separately from an other onboard electric equipment (such as alarm and lighting fires, monitors, etc.), to placing, a design and to which principles of functioning the Chapter the Onboard electric equipment is devoted. Management of functioning of system of ignition is carried out under control ECM, - principles of functioning of a control system are considered by the engine in the Head of the Power supply system and release.

In order to avoid risk of failure of semi-conductor elements, and also for the purpose of reception prevention элеткротравм, at service of components of systems of an electric equipment it is necessary to observe special safety measures. Remember that the generator and a starter directly are connected to the battery and in case of an overload or short circuit can become a cause of the fire. Performing works on service of the components located in an impellent compartment, try not to touch moving elements (крыльчатка the fan, приводные belts, etc.), clean hair, working clothes clasp on all buttons.

Starting electric equipment service, necessarily remove a watch, rings and other metal ornaments. Even at the disconnected battery the category of condensers at casual grounding of their plugs can lead to reception of an electric shock or a strong burn.

Do not suppose polarity infringement at battery connection. In structure of such components as the generator, electronic blocks of management and so forth enter semi-conductor elements which can be put out of action at wrong connection of wires.

At performance of start of the engine from the external power supply, or connection зарядного devices also observe polarity of connection of wires (Sections Start of the engine from the auxiliary power supply and Removal/installation, check and service of the storage battery see).

Never disconnect electroconducting from the battery, the generator or the diagnostic equipment at the working engine.

Do not suppose проворачивания the engine of the disconnected generator.

At all do not make stock-taking of target pressure of the generator by grounding of its plugs.

Do not apply to conductivity stock-taking in a chain the ohmmeters equipped manual dynamo-car.

At performance of any works on electric equipment service watch, that the negative wire has been disconnected from the battery.

Before use of electroarc welding without fail disconnect the battery, the generator and such components, as ECM systems of a food/ignition in order to avoid risk of their damage.
On the main page