Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
+ 3. Engines
+ 4. Cooling system
+ 5. An exhaust system
- 6. The power supply system
   + 6.1. The power supply system of carburettor engines
   - 6.2. The power supply system of engines with fuel injection
      6.2.1. Replacement of a filtering element of the air filter
      6.2.2. Removal and installation of the air filter
      6.2.3. Replacement of the fuel filter
      6.2.4. Removal and installation of the distributor of fuel
      6.2.5. Dismantling and assemblage редукционного the valve
      6.2.6. Removal and installation of the fuel accumulator
      6.2.7. Removal and installation of fuel atomizers
      6.2.8. Removal and installation турбокомпрессора
      6.2.9. Removal and installation of a fuel tank
      6.2.10. Removal and installation of the fuel pump
      6.2.11. Temperature regulator check
      6.2.12. Adjustment of idling of the engine
      6.2.13. Check of a starting atomizer
      6.2.14. Check of a regulator of pressure
      6.2.15. Check and adjustment of position of a plate of a measuring instrument of the expense of air
   + 6.3. The power supply system of the diesel engine
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

6.2.14. Check of a regulator of pressure
THE GENERAL DATA

Check spend on the cold engine.

PERFORMANCE ORDER
1. To disconnect a wire from "the minus" plug of the storage battery.
2. To disconnect колодку with wires from a regulator (fig. Basic elements of system of injection of fuel see).
3. Again to connect a wire to "the minus" plug of the storage battery.
4. To connect the voltmeter to contacts Pads and to include a starter. If the voltmeter shows pressure less than 8,0 In, it is necessary to search for malfunction in electroconducting.
5. To switch off ignition, to connect an ohmmeter to regulator contacts. Resistance should be 20 Ohm. If the ohmmeter shows the resistance which is distinct from 20 Ohm, means the heating coil and a regulator is faulty it is necessary to replace.


On the main page